Ariens 932 Series Service Manual download pdf (Page 21)

5 - 21

5.1 DEFLECTOR REMOTE

Deflector must stay in selected position while throwing

snow.

If deflector does not stay in set position:

1. Tighten nut beneath the control panel to increase

friction on pressure flange (

Figure 12).

If deflector does not follow full range of travel:

1. Push deflector remote all the way forward.

2. Loosen adjusting nuts on cable support bracket.

3. To adjust the deflector lower, slide cable down.

Tighten bottom nut.

4. To adjust deflector higher, slide cable up. Tighten

top nut.

5. Check travel and repeat adjustment as necessary.

5.2 DISCHARGE CHUTE

If chute does not stay in position while operating,

tighten nut on carriage bolt at pivot point to increase

tension on spring (

Figure 13).

Smooth and easy rotation of properly lubricated chute

with crank is obtained by adjusting pinion and chute

gear teeth so they mesh together.

SECTION 5 - SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

1. Nut

2. Pressure Flange

3. Adjusting Nuts

4. Cable Support Bracket

OS6700

Figure 12

1. Pinion

2. Chute Gear

3. Carriage Bolt

4. Spring

OS6741

OS6730

Figure 13

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 38 39

No comments

Ariens 932 Series Service Manual Page 21