Ariens 927069-14532 Specifications download pdf (Page 21)

GB - 21

PTO BELT REPLACEMENT

Remove (Figure 20)

1. Lower mower deck to the ground.

2. Pull idler towards the outside of the unit

and remove PTO belt from idler.

3. Remove PTO belt from mower deck

pulley and engine sheave.

Install (Figure 20)

1. Install PTO belt on engine sheave and

mower deck pulley.

2. Pull idler towards the outside of the unit

and place PTO belt on idler.

3. Slowly release idler until PTO belt rests

firmly against idler.

Short Term Storage

IMPORTANT: NEVER clean unit with

high-pressure water or store unit outdoors.

Remove all dirt, grease, leaves, etc. Store in

a clean dry area.

Inspect unit for signs of wear or damage.

Ensure all fasteners are properly tightened.

Long Term Storage

Follow all instructions under Short Term

Storage.

Remove and fully charge battery. Store in a

clean dry area.

Drain fuel from fuel tank.

Refer to Engine Manual for the proper engine

storage procedures.

Touch up all scratched or chipped paint

surfaces.

CAUTION: Use care when releasing

idler spring tension. Keep body parts

well away from idler when performing

this operation.

Figure 20

OA0023

4

3

1

2

Mower Deck Shown Removed For Clarity

1. PTO Belt

2. Idler Spring

3. Idler

4. Engine Sheave

STORAGE

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments