Ariens 927069-14532 Specifications download pdf (Page 20)

GB - 20

• The minimum engagement of thread for

both tie-rods is 1/4 in. (0.635 cm).

Adjust (Figure 18)

1. Remove tie-rod(s) from spindle(s).

2. Loosen jam nut(s) and turn tie-rod(s)

clockwise or counterclockwise until the

distance between the jam nuts is within

specifications.

3. Tighten jam nuts.

4. Install tie-rod(s) on spindle(s).

HYDROSTATIC BELT

REPLACEMENT

Remove (Figure 19)

1. Remove PTO belt (see PTO BELT

REPLACEMENT on page 21).

2. Push idler towards the inside of the unit

and remove hydrostatic belt from idler.

3. Remove hydrostatic belt from engine

sheave and hydrostatic transmission

pulley.

Install (Figure 19)

1. Install hydrostatic belt on hydrostatic

transmission pulley and engine sheave.

2. Push idler towards the inside of the unit

and place hydrostatic belt on idler.

3. Slowly release idler until hydrostatic belt

rests firmly against idler.

4. Install PTO belt (see PTO BELT

REPLACEMENT on page 21).

OA0030Figure 18

1. Spindle

2. Tie-Rod

3. Jam Nut

3

2

1

Front Distance

Front of

unit

Rear Distance

Front Distance – Rear Distance =

0 - 1/2 inches (0 - 1.27 cm)

2

3

CAUTION: Use care when releasing

idler spring tension. Keep body parts

well away from idler when performing

this operation.

Figure 19

OA0031

5

1

3

2

4

1. Idler Spring

2. Engine Sheave

3. Hydrostatic Belt

4. Hydrostatic

Transmission

Pulley

5. Idler

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments