Ariens 926057 Specifications Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
EN - 17
OPERATING POSITION
(Figure 7)
To connect the brush attachment to traction
unit:
1. Place attachment belts onto attachment
pulley.
NOTE: Holding down the attachment clutch
lever will make it easier to reconnect the
brush attachment to traction unit.
2. Tip traction unit back while guiding brush
attachment up and onto lower pivot rod.
3. Tilt traction unit back up level to bring it
together with brush attachment.
4. Install cap screws (one on each side at
top) to secure brush attachment to
traction unit.
5. Place attachment drive belts onto engine
sheave. It may be necessary to turn
engine sheave using recoil starter
handle (Figure 12).
6. Reinstall belt finger. Check belt finger
clearance (See Check Belt Finger
Clearance on page 22).
IMPORTANT: DO NOT bend belt finger out of
shape.
7. Install bottom cover with six cap screws.
8. Install belt cover.
9. Reinstall remote trigger cable to brush
assembly.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required due to working
conditions (heavy loads, high ambient
temperatures, dusty conditions, or airborne
debris).
* After first 5 hours of operation.
** Refer to Engine Manual for detailed
instructions.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
MAINTENANCE SCHEDULE
Service
Performed
Each
Use
Daily
(8 hrs.)
Every
25 hrs
Yearly
or
100
hrs
Check Dual
Handle
Interlock
Check
Fasteners
Check
Clutch
Operation
Clean
Engine
Clean Recoil
Guard Foam
Cover
Check
Engine Oil
General
Lubrication
Check
Clutch Cable
Adjustments
*
Check Tire
Pressure
Change
Engine Oil
**
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Comments to this Manuals

No comments