Ariens 926057 Specifications Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
EN - 16
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact a Ariens
dealer or an authorized engine
manufacturer's service center.
SERVICE POSITION
(Figure 7)
IMPORTANT: DO NOT tip unit up onto brush.
Remove the brush if maintenance requires
tipping the unit forward. Ensure unit is secure
and will not tip over. Strap or clamp unit onto
bench if required.
To separate the brush attachment from
traction unit:
1. Shut off engine, close fuel shut-off valve,
disconnect spark plug wire and allow
unit to cool completely. Place unit on a
flat level surface.
2. Remove belt cover.
3. Remove hardware attaching remote
trigger cable to brush assembly and
detach cable.
4. Remove six cap screws securing bottom
cover of traction unit and remove cover.
5. Remove cap screws and belt finger.
6. Remove attachment drive belts from
engine sheave (it may be necessary to
turn engine sheave using recoil starter
handle).
7. Remove cap screws securing brush
attachment to traction unit (one on each
side at top).
8. Tip traction unit back so that it comes
apart from brush attachment.
9. While brush attachment is supported on
traction unit lower pivot rod, remove
attachment drive belts from attachment
pulley.
10. Separate brush attachment from traction
unit.
MAINTENANCE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: ALWAYS remove key
and/or wire from spark plug before
assembly, maintenance or
service. Unintentional engine start
up can cause death or serious
injury.
CAUTION: Always support unit
frame and brush attachment when
loosening the cap screws holding
them together.
Figure 7
1
2
7
6
5
4
4
3
1. Belt Cover
2. Bottom Cover Rear Cap Screws
3. Bottom Cover
4. Bottom Cover Side Cap Screws
5. Pivot Rod
6. Brush Frame Adapter
7. Brush Frame Adapter Mounting Cap Screws
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Comments to this Manuals

No comments