Ariens 926057 Specifications download pdf (Page 24)

EN - 24

2. To gain belt clearance, back out the stop

screw from the frame until the drive plate

assembly can swing past it (Figure 15).

3. Pull idler away from traction drive belt

and remove belt from engine sheave. It

may be necessary to turn engine pulley

using recoil handle (Figure 16).

4. Remove traction drive belt from drive

plate assembly pulley (Figure 17).

5. Install new traction drive belt onto drive

plate assembly pulley and engine

sheave.

6. Pull the drive plate assembly toward the

friction disc and turn stop screw all the

way in.

7. Replace attachment drive belts (see

Attachment Drive Belts Replacement on

page 23).

FRICTION DISC REPLACEMENT

(Figure 17)

1. Place the unit into the service position

(See Service Position on page 16).

2. With axle locked, hold one wheel/tire so

friction disc will not rotate and remove

three self-tapping screws holding friction

disc to carrier.

3. Remove both wheel/tires.

4. Remove two spring clip pins from hex

shaft.

NOTE: Bearings are retained by flanges.

5. Remove right and left bearing flanges

from frame.

6. Slide hex shaft to the left enough to

remove pinion sprocket from hex shaft.

NOTE: Outside bearing will fall free from hex

shaft.

7. Slide hex shaft to the right enough to

remove friction disc.

8. Slide new friction disc onto hex shaft.

9. Slide hex shaft to the left and install

pinion sprocket and chain on hex shaft.

10. Slide hex shaft to the right until centered

in frame and install bearings on shaft

ends and retain with bearing flanges.

11. Install both wheel/tires.

12. Hold wheel/tire so friction disc will not

rotate and secure new friction disc to

carrier with three self-tapping screws.

13. Place unit into the operating position

(See Operating Position on page 17).

14. Adjust traction drive clutch (See Traction

Drive Clutch Adjustment on page 23).

Figure 16

1. Attachment Drive Belts Idler

2. Traction Drive Belt Idler

3. Engine Sheave

3

2

1

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Comments to this Manuals

No comments