Ariens 926057 Specifications download pdf (Page 12)

EN - 12

Throttle Lever

The throttle controls the engine speed. To

increase or decrease engine speed, adjust to:

1. Fast (normal or warm starts) to left

2. Part-Throttle at center

3. Slow (cold weather starts) to right

Electric Starter

The electric starter will start a properly

choked engine when the starter button is

pushed. Refer to Starting and Shut Off on

page 14.

Recoil Starter Handle

When pulled, handle will turn engine over.

IMPORTANT: DO NOT let handle snap back

against starter.

NOTE: When operating unit in the winter

months recoil guard foam cover must be

installed. See Recoil Guard Foam Cover

Installation on page 20.

Speed Selector Lever

Position lever in the appropriate notch to

control speed of forward and reverse travel.

FORWARD

:

(6) Fastest

(1) Slowest

IMPORTANT: DO NOT

change motion from

forward to reverse with

clutch engaged.

Forward or reverse speed

can be changed without

de-clutching.

REVERSE

:

(1) Slow

(2) Fast

Fuel Shut-Off Valve

IMPORTANT: The fuel shut-off valve MUST

be in the closed position prior to transporting

the unit.

The fuel shut-off valve has two positions:

BRUSH ANGLE ADJUSTMENT

Brush can be positioned either straight ahead

or angled 20º to either right or left. To change

the angle of the brush:

1. Release both clutch levers and wait for

all moving parts to come to a complete

stop.

2. Pull up on the Brush Angle Lock Lever

and hold. This will release the cable-

operated lock pin.

3. With the brush assembly resting on

ground, push/pull on handlebars to

rotate brush right or left.

4. With brush in the desired position,

release Brush Angle Lock Lever to lock

brush in position.

BRUSH HEIGHT ADJUSTMENT

IMPORTANT: If brush height is set too low,

brush can drive machine rearward when

attachment clutch is engaged. Engage brush

slowly with brush set at proper height.

The brush works best with the brush properly

leveled. To adjust the brush height:

1. Move the brush to a dusty, flat surface.

Leave the engine running.

2. Start the brush at a slow speed. Run the

brush in a stationary position for 30

seconds.

12 3

6

1

1

2

Open Position: Use

this position to run the

unit.

Closed Position: Use

this position to service,

transport, or store the

unit.

Brush Position Locked

Brush Position Unlocked

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Comments to this Manuals

No comments