Ariens 932035-724 Specifications download pdf (Page 15)

GB - 15

Choke Control Knob

1. Choke Closed position:

chokes off air to engine for

easier start.

2. Choke Open position:

allows for normal

operation.

IMPORTANT: Gradually

open choke after engine

starts.

Throttle

The throttle controls the engine

speed. To increase or decrease

the engine speed, adjust to:

1. Fast (normal or warm starts)

2.Part-Throttle

3.Slow (cold weather starts)

4.Stop (engine is off)

Electric Starter (932035, 101)

The electric starter will start a properly choked

and cranked engine when the starter button is

pushed. Refer to Starting and Shut-Off.

Recoil Starter Handle

When pulled, handle will turn engine over.

IMPORTANT: DO NOT let handle snap back

against starter.

Discharge Chute Deﬂector

ALWAYS position discharge chute deﬂector at

a safe angle before starting engine.

DO NOT throw snow any higher than

necessary.

Push deﬂector handle forward or down to

throw snow lower. Pull deﬂector handle up or

to the rear to throw snow higher.

IMPORTANT: If Chute Deﬂector does not stay

in set position, adjust as directed in Service

and Adjustments, or repair before operation.

Discharge Chute

Discharge chute rotates 220°.

ALWAYS position discharge chute in safe

direction and angle, away from operator and

bystanders, before starting engine.

Chute Crank

IMPORTANT: If chute does not stay in set

position, adjust as directed in Service and

Adjustments, or repair before operation.

Rotate the Chute with Discharge Chute Crank

Handle.

IMPORTANT: DO NOT force frozen chute

controls. Start engine and run for 3-5 minutes

to thaw. If still frozen, take to warm place until

controls are free.

Axle Lock Pin (932101, 309)

The axle lock pin is located on the right wheel

hub. Moving pin from the hub to the axle shaft

allows the right wheel to turn freely.

Scraper Blade

The scraper blade allows the back of the

housing to keep better contact with the surface

being cleared. It also prevents damage to the

housing from normal wear.

IMPORTANT: DO NOT allow Scraper Blade to

wear too far or Auger/Impeller housing will

become damaged.

Runners

The runners control the distance between the

scraper blade and the ground. Adjust runners

equally to keep blade level with the ground.

Refer to Pre-Start for recommended settings.

FILLING FUEL TANK

To add fuel to fuel tank:

1. ALWAYS place unit in open or well

ventilated area.

2. Stop engine and allow to cool.

3. Clean Fuel Cap and surrounding area to

prevent dirt from entering Fuel Tank.

4. Remove Cap.

IMPORTANT: DO NOT use gasohol or

gasoline containing alcohol. See Engine

Manual for correct type and grade of fuel.

5. Fill fuel tank to within 1/2 in (1,2 cm)

below bottom of ﬁller neck with unleaded

gasoline.

NOTE: 932101 and 309 tank capacity is 1

gallon (3.8 liters). Tank capacity of other

models is 3.5 quarts (3,3 liters).

6. Replace Fuel Cap and tighten.

7. ALWAYS clean up any spilled fuel.

1

2

OS1300

STOP

1

2

3

4

OL2720

WARNING: AVOID INJURY. Read

and understand Fuel Safety Rules in

Safety section before proceeding.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments