Ariens 932035-724 Specifications download pdf (Page 12)

GB - 12

Tools Required:

• Pliers

• Open-End Wrenches: 3/8, 7/16, 1/2, 9/16"

and/or Adjustable Wrench

• Tire Gauge

ASSEMBLY

Handlebar and Shift Rod

1. Remove lower wing knobs on handlebar

assembly (Figure 4).

2. Remove upper wing nut and bolt on shift

rod.

3. Loosen upper wing knobs on handlebar.

4. Loosen lower wing nut and bolt on shift

rod.

5. Put speed selector lever into fastest

reverse panel notch.

6. Rotate handlebar up so wing knob holes

align. Install and tighten all wing knobs.

7. Install wing nut and bolt removed in step 2

onto shift rod and tighten hardware.

Install Discharge Chute and Crank

Figures 5 and 6.

1. Grease discharge chute ring on blower

housing (if not already greased).

2. Remove mounting hardware from top of

engine.

3. Slide chute ring under retainer clip on

blower housing and put chute on housing.

4. Secure chute by fastening chute strap to

engine with hardware just removed.

NOTE:

Washers and lock nuts go on top of

chute strap.

5. Loosen mounting nut on chute and move

chute up or down so that chute ring is

approximately centered between retainer

clip and lower ring and tighten.

6. Slide chute crank rod through bracket

under handlebar and through hole in

panel.

7. Align chute crank rod with the universal

joint on chute and fasten with spring clip.

ASSEMBLY

WARNING:

AVOID INJURY. Read

and understand

Assembly and Fuel

Safety Rules

before proceeding.

WARNING:

Dropping or tipping over

boxed unit could result in personal

injury or damage to unit.

1. Handlebar

Assembly

2. Wing Knobs

3. Wing Nut

4. Speed Selector

5. Bolt

6. Shift Rod

1

2

4

5

6

Figure 4

3

OS0901

2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments