Ariens 932035-724 Specifications download pdf (Page 16)

GB - 16

PRE-START

1. Frozen Impeller

IMPORTANT: Before starting engine, check

impeller to be sure it is not frozen.

To check impeller:

1. With key in “Stop” position, squeeze

Attachment Clutch Lever to Engaged

position.

2. Pull Recoil Starter Handle.

3. If Impeller is frozen, (cannot pull Starter

Handle) move unit to a heated area and

thaw to prevent possible damage.

2. Check Function of Clutches

(932035, 503)

If clutches do not engage or disengage

properly, adjust or repair before operation (see

Service and adjustments).

3. Check Dual Handle Interlock

(932101, 309)

Without the engine running, press down

(engage) both clutch levers. Release

attachment clutch lever. Attachment clutch

should remain engaged until traction clutch

lever is released, then both clutches must

disengage.

If clutches do not engage or disengage

properly, adjust or repair before operation (see

Service and Adjustments).

4. Adjust Axle Lock (932101, 309)

Keep locking pin on the right wheel hub for

best traction when throwing snow.

5. Adjust Runners

Check and adjust Runners (see Service and

Adjustments). Allow 1/8 in (3 mm) between

scraper blade and hard, smooth surface(s).

Allow 1-1/4 in (30 mm) between scraper blade

and uneven or gravel surfaces.

6. Check Engine Fuel & Crankcase Oil

Check and add fuel if required. Check that the

engine crankcase oil is full using dipstick.

Refer to Engine Manual for detailed

instructions.

TO STOP IN AN EMERGENCY

Immediately release both control levers to stop

unit in an emergency. Stop engine, remove

key and wait for all rotating parts to stop before

leaving operator’s position.

STARTING AND SHUT OFF

IMPORTANT: Allow unit and engine to adjust

to the outdoor temperatures before clearing

snow. Before shut-off, run the attachment a

few minutes to prevent freeze-up.

NOTE: Try out each control without the engine

running to see how it works and what it does.

Manual Start

1. Turn discharge chute straight ahead.

2. Make sure that the traction clutch and

attachment drive clutch levers are fully

disengaged.

3. Push Primer Bulb 2 or 3 times for cold

engine.

NOTE: When temperature is below -15˚ F

(-26˚ C) additional priming may be needed.

4. If engine is cold, apply choke. See Engine

Manual for detailed instructions.

NOTE: A warm engine requires less choking

than a cold engine.

5. Set throttle to proper starting position.

6. Insert key into ignition switch and push

into RUN position. DO NOT twist key after

it is inserted.

7. Grasp starter handle and pull rope out

slowly until it pulls harder. Let rope rewind

slowly.

8. Pull rope with a rapid continuous full arm

stroke. Let rope rewind slowly.

IMPORTANT: DO NOT let Starter Handle

snap against Starter.

9. Repeat steps 7 and 8 until engine starts.

(If engine does not start, refer to

Troubleshooting.)

10. Adjust choke as needed.

11. Set throttle to Part Throttle or Slow

position for adaptation to outside

temperature or travel. Set throttle to Fast

position for normal operation.

WARNING: AVOID INJURY. Read

and understand Fuel Safety Rules in

Safety section before proceeding.

WARNING: FAILURE TO FOLLOW

INSTRUCTIONS could result in

personal injury and/or damage to

unit. DO NOT attempt to start your

unit at this time. Read entire Owner/

Operator Manual and the Engine

Manual ﬁrst.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comments to this Manuals

No comments