Ariens 932035-724 Specifications download pdf (Page 22)

GB - 22

SPEED SELECTOR ADJUSTMENT

To adjust (Figure 13):

1. Remove hair pin from adjustment pivot

pin.

2. Pull shift rod and adjustment pivot pin out

of speed selector lever.

3. Place the speed selector in the fastest

reverse speed position.

4. Pull the shift rod straight up towards the

control panel as far as it will go.

5. Thread the adjustment pivot pin along the

shift rod until it aligns with the mating hole

on the speed selector lever.

6. Turn adjustment pivot pin three turns up

the shift rod (Figure 13).

7. Reinsert the pivot pin into the hole on the

speed selector lever.

8. Check forward and reverse speeds.

a. Start unit.

b. Shift speed selector into ﬁrst forward

speed.

c. Engage traction clutch. Unit should

move forward.

d. Stop unit.

e. Shift speed selector into ﬁrst reverse

speed.

f. Engage traction clutch. Unit should

move backward.

g. Shut off unit.

9. Adjust pivot pin as needed so unit travels

forward when speed selector lever is in

ﬁrst forward position and backward when

speed selector lever is in ﬁrst reverse

position.

10. Secure adjustment pivot pin to speed

selector lever with hairpin.

ATTACHMENT DRIVE BELT

REPLACEMENT

Remove Attachment Drive Belt

(Figures 14 and 15)

1. Shut off engine, remove key, disconnect

spark plug wire and allow unit to cool

completely.

2. Remove two screws securing belt cover

to unit and remove belt cover.

3. Remove spring pin from chute crank rod

assembly at universal joint and separate.

4. Remove hardware holding chute strap to

engine mounting bracket and lift

discharge chute off housing.

5. Remove belt ﬁnger by removing cap

screws mounting belt ﬁnger to engine.

6. Remove attachment drive belt from

engine sheave (it may be necessary to

turn engine sheave using recoil starter

handle).

IMPORTANT: To avoid bending bottom cover,

when tipping unit apart, support handlebars

ﬁrmly or tip unit up on housing and remove

bottom cover by removing four cap screws

before separating unit.

7. Support Sno-Thro frame and housing.

8. Remove top two cap screws and loosen

lower cap screws holding blower housing

to frame (one on each side).

9. Separate housing from unit. Lower

handlebar on ﬂoor.

10. Remove attachment drive belt from lower

pulley (hold brake away from belt).

Figure 13

1. Shift Rod

2. Adjustment Pivot Pin

3. Speed Selector Lever

4. Hairpin

OSs0194

1

2

3

4

3 turns up the

shift rod

CAUTION: Always support

Sno-Thro frame and housing when

loosening the cap screws holding

them together. Never loosen cap

screws while unit is in service

position.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments