Ariens 920403 - Sno-Tek 28E Specifications download pdf (Page 23)

GB - 23

ATTACHMENT CLUTCH/BRAKE

ADJUSTMENT

Remove Attachment Cable Slack

(Figure 21 and 22)

1. Shut off engine, remove key, disconnect

spark plug wire and allow unit to cool

completely.

2. Loosen hardware securing belt cover to

unit.

NOTE: DO NOT completely remove

hardware from unit.

3. Remove belt cover.

4. Loosen jam nut on cable adjustment

barrel, and then turn the adjustment

barrel down to shorten cable and

remove all cable slack.

5. With the attachment clutch disengaged,

check that the attachment idler arm

lightly touches the frame.

6. Tighten jam nut on cable adjustment

barrel.

WARNING: IMPROPER

ADJUSTMENT could result in

unexpected movement of auger and

impeller causing death or serious

injury. AUGER / IMPELLER MUST

STOP within 5 seconds when

attachment clutch/impeller brake

lever is released.

WARNING: Adjustment procedure

requires the engine to be run with the

belt cover off. AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

Figure 20

1. Shift Rod

2. Adjustment Pivot Pin

3. Speed Selector Arm

4. Hairpin

OS8060

Figure 21

1. Attachment Clutch Cable

2. Cable Adjustment Barrel

3. Jam Nut

OS8260

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Comments to this Manuals

No comments

Ariens 920403 - Sno-Tek 28E Specifications Page 23

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 920403 - Sno-Tek 28E