Ariens 920403 - Sno-Tek 28E Specifications download pdf (Page 27)

GB - 27

2. Pull idler away from traction drive belt

and remove belt from idler, crankshaft

pulley and driven pulley (it may be

necessary to turn crankshaft pulley

using recoil starter handle).

3. Replace traction drive belt.

4. Swing drive plate toward friction disc to

slide finger into stop hole in frame.

Reinstall swing gate spacer.

NOTE: Make sure drive plate spring remains

connected to the frame and drive plate.

5. Replace attachment drive belt (See

Replace Attachment Drive Belt on

page 25).

FRICTION DISC REPLACEMENT

Remove Friction Disc

(Figure 31 and 32):

1. Shut off engine, remove key, disconnect

spark plug wire and allow unit to cool

completely.

2. Place the unit into the service position

on a level surface.

3. Remove lockpins from wheel axles and

remove wheels.

4. Remove bottom cover by removing six

hex bolts.

5. Disconnect pivot pin from the speed

selector arm. Save the hardware for

reinstallation.

6. Remove spring clip pin nearest drive

gear from hex shaft.

7. Remove left bearing flange from frame.

8. Slide hex shaft to the left to remove the

flat washer, pinion gear and friction disc

assembly from the hex shaft.

NOTE: Be sure to save washers between

bearing and sliding fork for reassembly.

9. Remove friction disc assembly from

frame.

10. Remove three screws holding friction

disc to carrier bearing.

11. Remove old friction disc. Put the new

friction disc in place, cup side to carrier

bearing.

12. Reinstall three screws into new friction

disc and carrier bearing. Torque to

5 – 6 lbf-ft. (6.8 – 8.13 N•m).

Figure 29

OS8170

1. Swing Gate Spacer

2. Swing Gate Finger

3. Drive Plate

3

1

2

Figure 30

OS8068

1. Swing Gate

2. Swing Gate Finger

3. Drive Plate

3

1

2

CAUTION: Before tipping unit,

remove enough fuel so that no spills

occur.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Comments to this Manuals

No comments