Ariens 920403 - Sno-Tek 28E Specifications download pdf (Page 26)

GB - 26

6. Replace chute crank and secure with

spring pin.

IMPORTANT: Reconnect chute lock cable

and deflector cable, if equipped (920402,

403).

7. Run in the attachment belt. See Run-in

Attachment Belt on page 11.

8. Replace belt cover and tighten

hardware.

TRACTION DRIVE BELT

REPLACEMENT

(Figures 26, 27, 28, 29 and 30)

NOTE: Housing and frame must be tipped

apart and attachment drive belt removed from

engine sheave in order to change traction

drive belt.

1. Remove attachment drive belt (See

Remove Attachment Drive Belt on

page 25).

NOTE: To gain belt clearance, remove swing

gate spacer (Figure 29) so drive plate can be

slid over until finger is out of frame and drive

plate can swing past stop hole in frame

(Figure 30).

WARNING: AVOID INJURY. Auger

must stop within 5 seconds when

attachment lever is released or

serious injury or unit damage may

result.

Figure 27

OS8160

1. Traction Belt

Idler

2. Traction Drive

Belt

3. Engine Sheave

4. Belt Finger

5. Attachment

Drive Belt

6. Attachment

Pulley

7. Attachment

Idler Nut

8. Attachment

Belt Idler

CAUTION: Always support the frame

and blower housing when loosening

the cap screws holding them

together. Never loosen cap screws

while unit is in service position.

Figure 28

1. Belt Finger

2. Belt

OS8165

1/8 in. (3.2 mm)

(Maximum)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Comments to this Manuals

No comments

Ariens 920403 - Sno-Tek 28E Specifications Page 26

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 920403 - Sno-Tek 28E