Ariens 920403 - Sno-Tek 28E Specifications download pdf (Page 22)

GB - 22

REMOTE DISCHARGE

DEFLECTOR CONTROL

ADJUSTMENT (920402, 403)

(Figure 18)

Deflector must stay in selected position while

throwing snow.

If deflector does not stay in set position:

1. Tighten nut beneath control panel to

increase pressure on deflector control

(Figure 18).

If deflector does not follow full range of travel:

1. Push deflector remote all the way to rear

most position.

2. Loosen adjusting nuts on remote

deflector cable attached to the chute

deflector (Figure 18).

3. To adjust the deflector lower:

Loosen bottom adjustment nut and

tighten top adjustment nut.

To adjust deflector higher:

Loosen top adjustment nut and tighten

bottom adjustment nut.

4. Check the deflectors range of travel and

repeat adjustment as necessary.

DISCHARGE CHUTE

(Figure 19)

If discharge chute does not stay in position

while operating, tighten nut on carriage bolt at

pivot point to increase tension on spring.

SPEED SELECTOR

ADJUSTMENT

(Figure 20)

To adjust:

1. Disconnect adjustment pivot pin from

speed selector arm. Save hardware for

reinstallation.

2. Place the speed selector on dash panel

in the fastest forward speed position.

3. Turn the speed selector arm straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector arm, and

then turn it up the shift rod 7 turns. Insert

the pivot pin into hole.

5. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

6. Check forward and reverse speeds:

a. Start unit.

b. Shift speed selector into the first

forward speed.

c. Engage the traction clutch. Unit

should move forward.

d. Stop unit.

e. Shift speed selector into first

reverse speed.

f. Engage the traction clutch. Unit

should move backward.

g. Shut off unit.

7. Adjust pivot pin on the shift rod as

necessary so unit travels forward when

speed selector is in first forward position

and travels backward when speed

selector is in first reverse position.

8. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

Figure 18

1. Adjusting Nuts

2. Cable Support Bracket

3. Remote Deflector Control Cable

2

1

3

Figure 19

1. Spring

2. Nut

1

2

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Comments to this Manuals

No comments