Ariens 992807-ProZoom 60 Specifications download pdf (Page 27)

GB - 27

SERVICE ACCESS

Raise the seat to access the battery and the

hydraulic reservoir. Use caution while lifting

and make sure the seat is locked in the

upright position before beginning service on

the mower.

Tipping Seat Forward

To lower the seat back down, push forward

on the seat slightly and pull the seat support

bar rearward out of the lock position. Lower

the seat slowly back into contact with the

frame.

NOTE: If unit is equipped with ROPS, the

seat latch must be engaged. Lift on seat to

make sure it is latched once lowered back

into position.

LUBRICATION AND MAINTENANCE

Engine Oil Level

IMPORTANT: Failure to check the engine oil

level regularly could lead to serious engine

problems if oil is too low.

1. Park the unit on level ground and shut

off the engine.

2. Clean the area around the engine

dipstick before removing it.

3. Remove the dipstick and wipe it off.

4. Momentarily reinstall the dipstick in the

engine (without turning it) and check that

the oil level is between the upper and

lower limit on the dipstick.

5. Add oil as necessary to achieve required

level.

DO NOT overfill.

6. Reinstall and tighten the dipstick.

7. Clean any spilled oil.

IMPORTANT: Use only the oil specified for

use in the engine manual.

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY.

Read and understand entire

Safety section before proceeding.

CAUTION: Shut off the engine

before servicing the mower.

Make sure the seat is fully raised

and locked before performing

any maintenance on the mower.

The seat can come down very

quickly once the seat lock lever

is released. Lower the seat

slowly making sure to pay close

attention that everything is clear.

CAUTION: Ensure that seat lock

is latched and fully engaged

when returning seat plate to

operating position.

Figure 15

Seat Support Bar

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 49 50

Comments to this Manuals

No comments