Ariens 992807-ProZoom 60 Specifications download pdf (Page 13)

GB - 13

Tires

See SPECIFICATIONS on page 45.

Hardware

Check for loose hardware.

Check Safety Interlock System

Check to see that the interlock system

operates correctly. (See Check Safety

Interlock System on page 13.)

Lubrication

Lubricate all fittings per maintenance label

under seat and check hydraulic oil level. (See

Lubrication and Maintenance on page 27.)

Hydraulic Oil Service

The power unit is shipped with hydraulic oil in

the system. If the tracking is erratic, purge the

system. (See Hydraulic System Maintenance

on page 29.) If the oil level is below the edge

of the baffle in the oil reservoir, fill with SAE

20W-50 motor oil.

Engine

Engine has been filled with a break in oil.

Change oil and filter after first 8 hours of use.

(See Lubrication and Maintenance on

page 27.)

Check Function of All Controls

Ensure unit runs and performs properly.

INSTALL ROLLOVER PROTECTION

STRUCTURE (ROPS)

Install Base Weldments

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is

possible when they are serviced

incorrectly:

• Do not attempt to mount a

tire without the proper

equipment and experience to

perform the job.

• Do not inflate the tires above

the recommended pressure.

• Do not weld or heat a wheel

and tire assembly. Heat can

cause an increase in air

pressure resulting in an

explosion. Welding can

structurally weaken or

deform the wheel.

• Do not stand in front or over

the tire assembly when

inflating. Use a clip-on chuck

and extension hose long

enough to allow you to stand

to one side.

WARNING: FAILURE OF

INTERLOCK together with

improper operation can

result in severe personal

injury.

WARNING: FAILURE OF

CONTROLS could result in death

or serious injury.

Figure 5

1. ROPS Lock Pin Assembly

2. 5/16 x 3/4 in. Round Knob

3. 1/2 x 3 1/4 in. Hex Bolt

4. 1/2 x 3 1/2 in. Hex Bolt

5. 1/2 in. Hex Nut

6. 1/2 in. Spring Lock Washer

7. 1/2 in. Center Lock Nut

8. Right Side Base Weldment

9. Left Side Base Weldment

10. Center Tube Weldment

2

3

1

4

5

6

7

9

8

10

F

r

o

n

t

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Comments to this Manuals

No comments