Ariens 992807-ProZoom 60 Specifications download pdf (Page 14)

GB - 14

1. Locate the left-side ROPS mount pocket

on the inside of the frame above the

wheel motor. Mount the left side base

weldment (item 9) in the pocket using

two 1/2 x 3 1/2 in. hex bolts (item 4), two

1/2 in. spring lock washers (item 6) and

two 1/2 in. hex nuts (item 5). Do not fully

tighten hardware. See Figure 5.

2. Locate the right-side ROPS mount

pocket on the inside of the frame above

the wheel motor. Mount the right side

base weldment (item 8) in the pocket

using two 1/2 x 3 1/2 in. hex bolts (item

4), two 1/2 x 3 1/2 in. hex bolts (item 4)

and two 1/2 in. spring lock washers (item

6). Do not fully tighten hardware. See

Figure 6.

Install Center Tube

1. Position center tube weldment (item 10)

in right- and left-side base weldments

with the top angle facing the rear of the

unit. Secure with two 1/2 x 3 1/4 in. hex

bolts (item 3) and two 1/2 in. center lock

nuts (item 7). Ensure that hinge bolts are

positioned to the rear of the unit. Do not

fully tighten. See Figure 7.

2. Install two ROPS lock pins (item 1) and

two 5/16 x 3/4 in. round knobs (item 2).

See Figure 7.

3. Torque lower mounting hardware

installed in steps 1 and 2 of Install Base

Weldments on page 13 to 80 lbf-ft (109

N•m).

4. Tighten upper mounting hardware

installed in step 1 until they just contact

the hinge plate. To ensure that rollover

bar can lower and raise correctly, do not

overtighten.

Tighten round knobs to prevent center tube

from rattling during operation.

Fill Fuel Tank

Fill fuel tank. DO NOT OVERFILL! See

FILLING FUEL TANK on page 19

Figure 6

ROPS Mount

Pocket

4

5

6

8

9

Figure 7

2

3

1

7

10

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Comments to this Manuals

No comments