Ariens 992807-ProZoom 60 Specifications download pdf (Page 31)

GB - 31

5. Install the red terminal boot over both

the positive post and the positive cable.

6. Secure the battery in place by inserting

one end of the hook band into the

battery tray and running the other end

over the top of the battery into the slot

on the opposite end of the battery tray.

Cleaning the Battery

Keep battery and its terminals clean. Inspect

every 100 operating hours or monthly for best

performance.

1. Remove battery from unit. See

Removing the Battery on page 30

2. Clean terminals and battery cable ends

with wire brush.

3. Coat terminals with dielectric grease or

petroleum jelly.

4. Replace battery. (See Installing the

Battery on page 30)

CHARGING THE BATTERY

Battery Electrolyte First Aid

Follow First Aid directions for contact with

battery fluid.

• External Contact: Flush with water.

• Eyes: Flush with water for at least 15

minutes and get medical attention

immediately!

• Internal Contact: Drink large quantities

of water. Follow with Milk of Magnesia,

beaten egg or vegetable oil. Get

medical attention immediately!

In case of internal contact, DO NOT induce

vomiting!

IMPORTANT: DO NOT fast charge. Charging

at a higher rate will damage or destroy

battery. ONLY use an automatic charger

designed for use with your battery.

ALWAYS follow information provided on

battery by battery manufacturer. Contact

battery manufacturer for extensive

instructions to charge battery.

1. Remove battery from unit. (See

Removing the Battery on page 30)

2. Place battery on bench or other well-

ventilated place.

3. Connect positive (+) lead of charger to

positive (+) terminal, and negative (–)

lead to negative (–) terminal.

4. Charge battery according to charger and

battery manufacturer’s instructions.

5. Replace battery. (See Installing the

Battery on page 30)

Jump-Starting

Ariens does not recommend jump-starting

your unit. Jump-starting can damage engine

and electrical system components. See your

engine manual for more detailed information.

Replacing Fuses

IMPORTANT: Avoid damage to the electrical

circuit. Use only the same size fuse as was

originally installed.

There are two fuses on your Ariens mower.

They are located on the frame on the inside.

One is close to the front of the fuel tank. The

second is located to the rear of the tank. Both

are 20 amp fuses.

1. Remove the defective fuse from the

socket.

2. Check the metal clip in the fuse window

and discard the fuse if it is broken.

3. Install the new fuse in its socket.

CASTERS

Servicing the Caster Wheel Roller

Bearings

1. Park the unit on a level service, put the

steering control levers in the park

position, turn off the engine and remove

the key.

2. Raise the front of the power unit and

support it with jack stands.

3. Remove the lock nut, bolt and wheel

assembly from the wheel fork assembly.

4. Remove the bushing caps, bearings and

the spacer tube from the wheel

assembly.

5. Clean and inspect the bearings and

pack with clean grease. Replace

bearings as needed.

6. Install the spacer tube, bearings, and

new bushing caps.

1. Positive

terminal

2. Negative

terminal

Figure 19

OM4316

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 49 50

Comments to this Manuals

No comments