Ariens 992807-ProZoom 60 Specifications download pdf (Page 39)

GB - 39

Deck Belt Removal and Installation

1. Disconnect the drive belt according to

Drive Belt Removal and Installation

instructions.

2. Remove the 3/8-16 x 2-1/2" bolt and 3/8-

16" locknut from under the pulley

standoff arm. Remove the arm, making

sure the pivot bushings do not fall out.

3. Release tension on the deck belt by

backing off and releasing the belt

tension rod.

4. Remove both belt shields and remove

the deck belt.

5. Install a new deck belt, routed according

to instructions found on the decal on the

bottom of the floor plate.

6. Reconnect the deck belt tension rod and

tighten the 3/8-16" nut until the tension

spring measures 5-9/16” from hook end-

to-hook end. Tighten the other nut

against the rod bracket to lock. Install

both deck belt shields.

7. Reinstall the drive belt idler pulley

standoff arm, ensuring the rod end is

inserted in its bracket near the clutch.

Lightly lubricate the pivot bushings with

MP Lithium grease, install and retain

with the removed 3/8-16" fasteners.

8. Reinstall or reconnect the drive belt

according to Drive Belt Removal and

Installation instructions.

Pump Belt Removal and Installation

1. Make sure the mower is on a firm level

surface, the PTO switch is off, the

engine is shut off, the steering control

levers are in the park position, the

negative battery cable is removed, and

the lift control lever is unlocked.

2. Place the deck in the highest position.

3. Release the deck belt tension by

disengaging the deck tension arm.

Remove the belt from the electric clutch.

It is not necessary to remove the belt

from any other pulleys.

4. Release the tension from the pump belt

by loosening the outside jam nut on the

threaded rod bolt. Then back off inside

nut to remove tension. Pull back on the

tension arm and pull the belt out from

behind the pulley.

5. Slide the belt off of the engine pulley.

Slide the belt above the engine pulley to

allow the belt to be removed from the

other pulleys.

6. Slide the belt off of the pump pulleys.

7. Install the new belt by sliding it above

the engine pulley. Route the belt as

shown in figure 33.

8. First tighten nut on outside of frame fully

first to set the proper tension. Then

tighten inside nut to lock the position of

the threaded rod.

Figure 32

Belt Routing

Deck Belt

Adjust Spring Tension Length to 5-9/16"

End to End

Deck Drive Belt

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 49 50

Comments to this Manuals

No comments