Ariens 926324 Specifications download pdf (Page 33)

EN - 33

BATTERY

(926513, 516)

Charging

1. Place unit on a level surface and shut off

engine.

2. Disconnect negative (–) cable first, then

positive (+) cable.

3. Loosen wing nut and remove battery.

Place battery on bench or other well-

ventilated place.

4. Connect positive (+) lead of charger to

positive (+) terminal, and negative (–)

lead to negative (–) terminal.

5. Charge the battery at two and a half

amps for ten hours.

6. Reinstall battery into unit and connect

positive (+) cable first, then negative (–)

cable.

Replacing

Use U1R or U1L; 240 CCA minimum @ 18°C

type batteries.

TRACK TENSION ADJUSTMENT

(926324)

(Figure 36 and 37)

Check the track tension by applying pressure

on the track midway between the upper and

rear track rollers. Deflection should be

approximately 9,6 mm (Figure 36).

If deflection is excessive, tighten the track

tension.

If unit pulls to the left or right when a straight

path is desired adjust the track tension. If the

unit is pulling to the left, tighten the left track

adjuster. If the unit is pulling to the right,

tighten the right track adjuster.

To adjust (Figure 37):

1. Tighten the adjuster nut to tighten the

track tension.

Loosen the adjuster nut to reduce track

tension.

2. Check that unit tracks straight with no

pulling to either side.

HEIGHT ADJUSTER CABLE

ADJUSTMENT

(926324)

(Figure 38)

1. Make sure that height adjustment lock

finger is fully engaged.

2. Loosen jam nut on cable adjustment

barrel.

3. Turn the adjustment barrel to remove all

cable slack and bring the overtravel arm

until it makes slight contact with the right

end of the slot in the height adjuster lock

finger.

4. Tighten the jam nuts.

Figure 36

9,6 mm

Figure 37

Track

Adjusters

Figure 38

1. Height Adjuster Lock Finger

2. Overtravel Arm

3. Height Adjuster Cable

4. Jam Nuts

3

2

1

Before adjusting ensure

that height adjuster lock

finger is fully engaged.

Pin on overtravel arm

makes slight contact

with end of slot.

4

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments