Ariens 926324 Specifications download pdf (Page 32)

EN - 32

TRACTION DRIVE BELT

REPLACEMENT

(Figure 34)

NOTICE: Replacement will be easier with

housing and frame tipped apart and bottom

cover off.

1. Remove attachment drive belts (see

Remove Old Attachment Drive Belts on

page 31).

2. To gain belt clearance, back out the stop

bolt from the frame until the drive plate

assembly can swing past it (Figure 34).

3. Pull idler away from traction drive belt

and remove belt from idler pulley, engine

sheave and driven pulley (it may be

necessary to turn engine pulley using

recoil handle).

4. Install new traction drive belt onto driven

pulley and engine sheave.

5. Pull the drive plate assembly toward the

friction disc and tighten the stop bolt.

NOTICE: Make sure the drive plate assembly

return spring remains connected to the frame.

6. Replace attachment drive belts (see

Install New Attachment Drive Belts on

page 31).

FRICTION DISC REPLACEMENT

(Figure 35)

1. Place unit into service position.

2. Remove bottom cover by removing six

hex bolts.

3. With axle locked, hold one wheel so

friction disc will not rotate and remove

three cap screws holding friction disc to

carrier.

4. Remove both wheels.

5. Remove right and left bearing flanges

from frame.

6. Slide hex shaft to the left enough to

remove pinion sprocket from hex shaft.

7. Slide hex shaft to the right enough to

remove friction disc.

8. Slide new friction disc onto hex shaft.

9. Install pinion sprocket and chain on hex

shaft, then replace bearing flanges.

10. Replace wheels.

11. Hold wheel so friction disc will not rotate

and secure new friction disc to carrier

with three hex screws removed in

step 3.

12. Replace bottom cover.

13. Adjust traction drive clutch. See Traction

Drive Clutch Adjustment on page 30.

Figure 34

1. Traction Drive Belt

2. Engine Sheave

3. Belt Finger

4. Attachment Belts Idler

5. Attachment Pulley

6. Attachment Idler Adjustment Nut

7. Traction Belt Idler

8. Traction Drive Pulley

9. Stop Bolt

1

2

3

4

7

8

5

6

9

Figure 35

1. Cap Screw

2. Torx Screw

3. Friction Disc

4. Pinion Sprocket

5. Bearing Cap

6. Hex Shaft

7. Drive Plate Assembly

8. Stop Bolt

1

2

3

1

6

1

1

8

7

4

5

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments