Ariens 926324 Specifications download pdf (Page 16)

EN - 16

CONTROLS AND FEATURES

See CONTROLS AND FEATURES on

page 14 and page 15 for all Controls and

Features locations.

Dual Handle Interlock

When Attachment Clutch and then Traction

Drive Clutch are engaged, the Attachment

Clutch will remain engaged (lever down) if

released. To stop attachment, release

Traction Drive Clutch and both clutches will

disengage.

Traction Drive Clutch –

Left Hand Lever

Squeeze the Traction

Drive Clutch Lever

against the Handlebar

(1) to engage wheel

drive for propelling unit.

Forward speed will

vary according to snow

depth and moisture

content.

Release lever (2) to

stop movement.

NOTICE: When traveling to or from the area

to be cleared, press down on the handlebars

enough to raise the front of the unit slightly off

the surface. Engage the traction drive clutch

without engaging the attachment drive clutch.

Attachment Clutch –

Right Hand Lever

Squeeze Attachment

Clutch Lever against

handlebar (1) to

engage attachment.

Release both clutch

levers (2) to disengage

power and apply brake

to attachment.

IMPORTANT: If the

belt squeals when the

attachment clutch lever

is engaged, the

impeller may be frozen in the auger housing.

Immediately release the attachment clutch

lever and move the unit into a heated area to

thaw.

NOTICE: If belt squeals when impeller turns

freely, see Attachment Clutch/Brake

Adjustment on page 28.

Ignition Switch (220V start)

(926321, 324)

Operate the ignition switch

with the removable key. To

start the engine, turn the key to

Start (2). To stop the engine,

turn the key to Off (1).

Ignition Switch (12V start on dash

panel)

(926513, 516)

The ignition switch is

operated by a removable

key. It has three positions:

1.Stop

2.Run

3.Start

Primer Bulb

Pushing the primer bulb in adds

fuel for easier engine start.

Refer to Starting and Shut Off

on page 20.

OPERATION

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: To avoid injury to hands

and feet, always disengage

clutches, shut off engine, and wait

for all movement to stop before

unclogging or working on snow

thrower.

Keep hands and feet away from

auger and impeller.

1

2

1

2

1

2

1

2

3

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments