Ariens 921040 - Platinum 30 SHO Specifications download pdf (Page 15)

EN - 15

Check Function of Dual Handle

Interlock

Without the engine running, press down

(engage) both clutch levers. Release

attachment clutch lever. Attachment clutch

should remain engaged until traction clutch

lever is released, then both clutches must

disengage. If they do not, contact your Dealer

for repairs.

Check Tire Pressure

Check tire pressure and adjust to the

pressure listed on tire sidewall.

Check Auger Gearcase Oil

Check oil level in auger gearcase (see Check

Auger Gearcase on page 24).

Check Engine Crankcase Oil

IMPORTANT: The engine may be shipped

with oil in crankcase. Refer to Engine Manual

for detailed instructions.

Fill Engine Fuel Tank

Fill fuel tank. DO NOT OVERFILL! See

FILLING FUEL TANK on page 19

If Applicable - remove the protective wrap

from the fuel tank and install the fuel cap

located in the attached bag.

Check Function of all Controls

Ensure unit runs and performs properly. Refer

to OPERATION on page 17.

Run-in Attachment Belt

1. Start unit in a well-ventilated area

according to Starting and Shut Off on

page 20.

2. Engage attachment clutch lever and run

attachment for about 15 minutes.

3. Stop unit, wait for all moving parts to

stop, and remove spark plug wire.

4. Adjust clutch idler according to

Attachment Clutch/Brake Adjustment on

page 28.

5. Adjust belt finger, if necessary. See

Check Belt Finger Clearance on

page 30.

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is

possible when they are serviced

incorrectly:

• Do not attempt to mount a tire

without the proper equipment and

experience to perform the job.

• Do not inflate the tires above the

recommended pressure.

• Do not weld or heat a wheel and

tire assembly. Heat can cause an

increase in air pressure resulting in

an explosion. Welding can

structurally weaken or deform the

wheel.

• Do not stand in front or over the

tire assembly when inflating. Use a

clip-on chuck and extension hose

long enough to allow you to stand

to one side.

Figure 15

2

3

1. Round Head Square Neck Bolt

2. Skid Shoe

3. Flat Washer

4. Locking-Center Nut

1

4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comments to this Manuals

No comments