Ariens 921040 - Platinum 30 SHO Specifications download pdf (Page 27)

EN - 27

If deflector does not follow full range of travel:

1. Push deflector remote forward.

2. Loosen adjusting nuts on cable support

bracket on side of chute deflector

(Figure 25).

3. a. To adjust the deflector lower:

Slide cable up and tighten top nut.

b. To adjust deflector higher:

Slide cable down and tighten bottom

nut.

4. Check travel and repeat adjustment as

necessary.

DISCHARGE CHUTE

(Figure 26)

If chute does not stay in position while

throwing snow or if chute does not rotate

freely, adjust the cable under the gear cover

so the chute lock fingers engage or

disengage the locking gear.

If chute does not stay in position:

Loosen the cable by loosening the rear

adjustment nut, and then tightening the

forward adjustment nut against the bracket

until the lock arm engages the gear teeth.

If chute does not rotate freely:

Tighten the cable by loosening the forward

adjustment nut, and then tightening the rear

adjustment nut against the bracket until all

cable slack is removed and lock arm engages

teeth. (Figure 26).

SPEED SELECTOR ADJUSTMENT

(Figure 27)

To adjust:

1. Disconnect adjustment pivot pin from

speed selector lever by removing

hairpin.

2. Place the speed selector on the control

panel in the fastest forward speed

position.

3. Turn the speed selector lever straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector lever. Insert

the pivot pin into hole.

Figure 24

Control Lever Nut

Figure 25

Adjustment

Nuts

Figure 26

1. Forward Adjustment Nut

2. Rear Adjustment Nut

3. Lock Arm

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comments to this Manuals

No comments

Ariens 921040 - Platinum 30 SHO Specifications Page 27

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 921040 - Platinum 30 SHO