Ariens 92 Specifications download pdf (Page 21)

GB - 21

AUGER EDGE REPLACEMENT

Over time the rubber edges of the auger will

wear. Contact your Ariens Dealer for

replacement.

IMPORTANT: Replace rubber edges before

metal auger begins to wear.

NOTE: After replacement of auger rubber

edges, adjust scraper blade. See Scraper

Blade Adjustment below.

SCRAPER BLADE ADJUSTMENT

IMPORTANT: Damage to auger/impeller

housing will result if blade wears down too far.

Scraper blade is adjustable to compensate for

wear.

To adjust scraper blade:

1. Tip unit back onto handlebar, support

housing and loosen nuts retaining blade.

2. If unit does not scrape cleanly, move

scraper blade forward. If unit does not

drive forward and scraper blade drags,

move scraper blade to the rear.

Tighten hardware and test unit. Repeat

adjustment as required until proper operation

is obtained.

SHORT TERM

IMPORTANT: NEVER spray unit with high

pressure water or store unit outdoors.

Run with attachment clutch engaged a few

minutes after each use to free unit of any

loose or melting snow.

Inspect unit for visible signs of wear, breakage

or damage.

Keep all nuts, bolts and screws properly

tightened and know unit is in safe working

condition.

Store unit in a cool, dry protected area.

LONG TERM

Clean unit thoroughly with mild soap and low

pressure water and lubricate (see

Maintenance). Touch up all scratched painted

surfaces.

Remove weight from wheels by putting blocks

under frame or axle.

When storing unit for extended periods of time,

remove all fuel from tank and carburetor (run

dry). Refer to Engine Manual.

STORAGE

WARNING: AVOID INJURY. Read

and understand Storage Safety Rules

in Safety section before proceeding.

TROUBLESHOOTING

PROBLEM PROBABLE CAUSE CORRECTION

Engine will not

crank/start.

1. Fuel tank is empty.

2. Build up of dirt and residue

around governor/carburetor.

3. Key Switch not in run

position.

4. Electric starter not

functioning.

5. Engine ignition problems.

1. Fill fuel tank.

2. Clean area around governor/

carburetor.

3. Put Key Switch into run

position.

4. Check for a bad starter or

connections.

5. See Engine Manual.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments