Ariens 92 Specifications download pdf (Page 11)

GB - 11

MAINTENANCE AND SERVICE

SAFETY RULES

Before cleaning, removing clogs or making

any inspections, repairs, etc.: disengage

clutch(es), stop unit and engine, remove

key, allow moving parts to stop. Allow hot

parts to cool.

Before tipping unit up onto housing, remove

enough fuel so no spills will occur. Ensure unit

is secure and will not tip over during

maintenance.

ALWAYS keep protective structures, guards,

and panels in good repair, in place and

securely fastened. NEVER modify or remove

safety devices.

DO NOT change engine governor settings or

over-speed engine.

Fumes from engine exhaust can cause injury

or death. DO NOT run engine in an enclosed

area. Always provide good ventilation.

ALWAYS maintain unit in safe operating

condition. Damaged or worn out mufﬂer can

cause ﬁre or explosion.

Keep all hardware properly tightened. Check

shear bolts frequently.

Maintain or replace safety and instruction

labels, as necessary.

STORAGE SAFETY RULES

NEVER store with fuel in fuel tank, inside a

building where any ignition sources are

present.

Allow engine to cool completely.

For extended storage, clean unit thoroughly.

See Engine Manual for proper storage.

ACCESSORY AND ATTACHMENT

SAFETY RULES

Use only attachments or accessories

designed for your unit.

Check components frequently. If worn or

damaged, replace with manufacturer’s

recommended parts.

Tools Required

• Pliers

• Open-End Wrenches: 3/8, 7/16, 1/2,

9/16 in and/or Adjustable Wrench

• Tire Gauge

Handlebar

Unfold upper handlebar until it snaps into

position on the lower handlebar.Tighten the

handlebar knobs to secure.

Discharge Chute (932103, 310)

1. Grease discharge chute ring if not already

greased (Figure 4a).

2. Remove mounting hardware and chute

crank support from top of engine.

3. Slide discharge chute over opening on

housing and under the retaining clip.

4. Position chute support bracket over studs.

5. Place the chute crank support on the

studs, over the chute support bracket.

6. Secure chute crank and chute support

brackets to studs with mounting hardware

just removed.

NOTE:

Make sure the discharge chute sits

ﬂush on the discharge chute ring before

tightening hardware.

7. Insert the chute crank through the hole in

chute crank support.

8. Remove the spring clip from the chute

pinion gear, insert chute crank into pinion

and secure with spring clip.

ASSEMBLY

WARNING:

AVOID INJURY. Read

and understand

Assembly

and

Fuel

Safety Rules

before proceeding.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments