Ariens 92 Specifications download pdf (Page 16)

GB - 16

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that

could be damaged.

DO NOT transport machine while engine is

running.

SERVICE POSITION

Place unit on a ﬂat level surface. Before tipping

unit up onto housing, remove enough fuel so

no spills will occur. Tip unit forward onto front

of Impeller housing for service. Assure unit is

secure and will not tip over. Strap and clamp

onto bench if needed.

MAINTENANCE SCHEDULE

The chart below shows the recommended

maintenance schedule that should be

performed on a regular basis. More frequent

service may be required.

* After ﬁrst two hours of operation.

CHECK FASTENERS

Make sure all hardware is tightened properly.

CHECK ATTACHMENT CLUTCH

Auger / impeller must stop within 3 seconds

when attachment clutch bail is released or unit

damage or serious injury may result.

If clutch does not engage or disengage

properly, adjust or repair before operation (see

Service and Adjustments).

CLEAN ENGINE

Refer to Engine Manual for detailed

instructions.

CHECK ENGINE OIL

The engine crankcase oil should be checked

every 5 hours of operation. Oil level MUST be

maintained in safe operating range on dipstick

at all times or engine damage will result (See

Engine Manual).

Park unit on a level surface. Refer to Engine

Manual for detailed instructions.

CHANGE ENGINE OIL

Change oil after ﬁrst two (2) hours of

operation, thereafter change oil every 25

hours (more often if required). Refer to Engine

Manual for detailed instructions.

NOTE: Sno-Thro has an oil drain cut-out on

the left side of unit frame. Drain engine oil

through this cut-out to prevent spills.

CHECK TIRE PRESSURE

Keep tires at pressure listed on the tire

sidewall.

CHECK AUGER GEARCASE

IMPORTANT: Proper oil level must be

maintained.

Gear cases are ﬁlled to the correct level at the

factory. Unless there is evidence of leakage,

no additional lubricant should be required.

Check oil level each season or every 25 hours

of operation.

MAINTENANCE

WARNING: AVOID INJURY. Read

and understand Maintenance and

Service/Fuel Safety Rules before

proceeding.

MAINTENANCE SCHEDULE

Each

Use

Every

5 hrs.

Every

25 hrs.

Yearly

Check

Fasteners

•

Check

Attachment

Clutch

•

Clean

Engine

•

Check

Engine Oil

•

Change

Engine Oil

*

•

Check Tire

Pressure

•

Check Auger

Gearcase

••

General

Lubrication

••

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Comments to this Manuals

No comments