Ariens Snow Blower 920006 User Manual download pdf (Page 14)

GB - 14

Recoil Starter Handle

When pulled, handle will turn engine over.

IMPORTANT: DO NOT let handle snap back

against starter.

See Starting and Shut Off on page 16.

Snow Clean-Out Tool (Figure 9)

To clear the discharge chute:

1. Shut off the engine.

2. Wait 10 seconds and make sure impeller

blades have stopped rotating.

3. Remove the snow clean-out tool (1) from

the auger housing and use it to remove

the clog from the discharge chute.

4. Replace the snow clean-out tool on the

auger housing.

Discharge Chute Deflector

ALWAYS position discharge chute deflector

at a safe angle before starting engine.

DO NOT throw snow any higher than

necessary.

Push deflector handle forward or down to

throw snow lower. Pull deflector handle up or

to the rear to throw snow higher.

IMPORTANT: If Chute Deflector does not

stay in set position, adjust as directed in

SERVICE AND ADJUSTMENTS on page 20,

or repair before operation.

Discharge Chute

Discharge chute rotates 205°.

ALWAYS position discharge chute in safe

direction and angle, away from operator and

bystanders, before starting engine.

Discharge Chute Crank

IMPORTANT: If chute does not stay in set

position, adjust as directed in SERVICE AND

ADJUSTMENTS on page 20, or repair before

operation.

Rotate the chute with the discharge chute

crank handle.

IMPORTANT: DO NOT force frozen chute

controls. If frozen, take to warm place until

controls are free.

Axle Lock Pin (Figure 10)

Use the axle lock pin to lock or unlock the

right or left wheel. Lock both wheels to

increase traction; unlock one wheel to allow

for easier turning of the unit.

NOTE: Unit will not drive with both wheels

unlocked.

WARNING: Hand contact with the

rotating impeller is the most common

cause of injury associated with snow

throwers. Never use your hand to

clean out the discharge chute.

1

Figure 9

OS8040

1. Snow Clean-Out Tool

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Comments to this Manuals

No comments