Ariens 938018 - SS722EC Specifications download pdf (Page 17)

GB - 17

3. Loosen belt finger and rotate until there

is 1/32 – 1/16 in. (0.8 – 1.6 mm) gap

between belt finger and drive belt.

4. Tighten belt finger.

5. Recheck gap between belt finger and

drive belt. Adjust belt finger until there is

1/32 – 1/16 in. (0.8 – 1.6 mm) gap

between belt finger and drive belt.

6. Go to Check Auger Stopping Time next.

Check Auger Stopping Time

1. Start unit.

2. Engage auger clutch bail for 5 seconds.

IMPORTANT: Auger MUST STOP within 5

seconds of disengaging auger clutch bail.

3. Disengage auger clutch bail.

• If auger stops within 5 seconds, the

adjustment is complete.

• If auger does not stop within 5 seconds,

repeat the entire procedure in Drive Belt

Adjustment on page 16.

IMPORTANT: Replace the drive belt if the

Drive Belt Adjustment procedure has been

completed twice and the drive belt is still not

adjusted properly.

4. Replace cowl.

WARNING: Improper adjustment

could result in death or serious injury.

Auger brake MUST DISENGAGE

when clutch is engaged. Auger brake

MUST STOP AUGER WITHIN 5

SECONDS of releasing auger clutch

bail.

WARNING: ROTATING PARTS can

cut off body parts. Keep hands and

feet away. Loose clothing, long hair

or scarves can get caught in rotating

parts and cause death or serious

injury.

WARNING: Auger MUST NOT rotate

when the auger clutch bail is

disengaged.

Figure 12

OS4501

1. Idler

2. Idler Nut

3. Belt Finger

4. Drive Belt

3

2

1

3

1/32 – 1/16 in.

(0.8 – 1.6 mm)

4

4

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments