Ariens 938018 - SS722EC Specifications download pdf (Page 8)

GB - 8

If fuel is spilled on clothing, change clothing

immediately.

Before tipping unit up onto housing, remove

fuel so no spills will occur. Ensure unit is

secure and will not tip over during

maintenance.

ALWAYS keep protective structures, guards,

and panels in good repair, in place and

securely fastened. NEVER modify or remove

safety devices.

DO NOT change engine governor settings or

over-speed engine.

Fumes from engine exhaust can cause injury

or death. DO NOT run engine in an enclosed

area. Always provide good ventilation.

ALWAYS maintain unit in safe operating

condition. Damaged or worn out muffler can

cause fire or explosion.

Keep all hardware properly tightened.

Maintain or replace safety and instruction

labels, as necessary.

NEVER store unit with fuel in fuel tank, inside

a building where any ignition sources are

present such as hot water heaters, space

heaters, or clothes dryers. Allow the engine to

cool before storing in any enclosure.

Drain fuel and allow engine to cool

completely before storing in closed area or

covering unit.

For extended storage, clean unit thoroughly.

See Engine Manual for proper storage.

Use only attachments or accessories

designed for your unit.

Check components frequently. If worn or

damaged, replace with manufacturer’s

recommended parts.

TOOLS REQUIRED

7/16" Open-end wrench, Pliers

ASSEMBLY

Handlebar Assembly

1. Remove wing knobs and release J-bolts

from lower handlebar (figure 3).

2. Unfold upper handlebar.

NOTE: Adjust handlebar to a height

comfortable for the operator (see Handlebar

Height Adjustment on page 12).

3. Put J-bolts through the upper handlebar

and lower handlebar holes.

4. Replace and tighten wing knobs to

secure upper handlebar.

ASSEMBLY

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

DS0072

4

3

1

6

2

5

Figure 3

1. Lower Handle

Bar

2. Upper Handle

Bar

3. Auger Clutch

Bail

4. Knob

5. J-Bolt

6. J-Bolt Holes

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments