Ariens 924 SNO-THRO 924112 Service Manual download pdf (Page 34)

9 - 34

9.5 DEFLECTOR

To install a new deflector cable: (Figure 31)

1. Remove e-ring and flat washer from stud on

discharge chute.

2. Route deflector cable between the chute and the

chute pedestal.

3. Slide cable end through hole on bracket on left side

of chute.

4. Attach cable eye to stud on deflector. Hold in place

with flat washer and e-ring.

5. Check deflector travel. Adjust nut on cable end

under handle bar to obtain full travel.

Figure 31

9.6 RUNNERS

Runners should be adjusted as conditions require.

Raising or lowering runners controls distance scraper

blade is held above surface being cleared.

When operating machine on gravel surface, lower

runners so that housing will not pick up gravel. On

concrete, blacktopped or packed down snow surfaces,

raise runners so that scraper blade scrapes clean. To

reduce tendency of housing to ride up over heavy wet

or hard-packed snow, remove runners and re-install

with the narrow edge down.

Position unit on a flat level surface. Adjust runners by

inserting a spacer of desired thickness under center of

scraper blade, loosen hardware, slide runners to flat

surface and retighten hardware.

NOTE: Above method keeps housing level by adjust-

ing runners equally. Uneven runners make machine

difficult to steer and results in uneven clearing.

PS1091

1. Deflector Cable

2. Chute Rod

3. Compression Spring

CAUTION: Adjust auger/impeller housing

height to clear gravel or crushed rock

surfaces.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 42 43

No comments

Ariens 924 SNO-THRO 924112 Service Manual Page 34