Ariens 992807-ProZoom 60 Specifications download pdf (Page 11)

Battery Maintenance

Use caution when charging the battery or

performing maintenance on the battery and

electrical system.

Use a voltmeter to check the state of the

charge.

If using a battery charger make sure it is

unplugged before connecting or

disconnecting the cables to the battery.

Batteries contain sulfuric acid electrolyte.

Always wear protective clothing and eye

protection when servicing.

In case of electrolyte contact, rinse area with

plenty of water and seek medical attention.

Make sure the battery is charged in a well-

ventilated location so hydrogen gases that

are produced while it is charging can

dissipate. Halt charging if battery exceeds

52°C (125°F).

Keep sparks, flames, and smoking material

away from the battery at all times. To avoid

sparks, use care when removing battery

cables from their posts.

Disconnect the battery's ground cable before

working on or near any electrical parts.

Tire Maintenance

CAUTION: Separation of a tire

and rim can cause an explosion

that could cause serious injury or

death.

Check the tires for low pressure,

cuts, bubbles, damaged rims, or

missing lug bolts and nuts.

Always use a clip-on chuck with

an extension long enough to

allow you to stand on one side of

the wheel while inflating the tires.

Do not stand directly in front of

the tire while inflating.

Never weld or heat a tire and

wheel assembly. The heat can

cause the air inside of the tire to

expand and result in a tire

explosion. Welding also can

structurally weaken or deform the

wheel.

Always ensure the tires are inflated to the

correct pressure. Do not inflate the tires

above the recommended pressure.

Make sure all hardware, especially the wheel

nuts and bolts have been tightened to the

correct torque.

When removing a tire from the power unit, it

is necessary to support it with blocks or

stands, not a hydraulic jack.

Do not attempt to service a tire unless you

have the proper equipment and experience to

perform the job. If you are not qualified to

make the repairs, take the unit to your Ariens

dealer or a qualified repair service.

When seating tire beads on the rims, never

exceed 2,4 bar (35 p.s.i.) or the maximum

inflation specified on your tires. Inflation

beyond this maximum pressure may break

the bead, or even the rim, with dangerous

explosive force.

Replacement Parts

Where replacement parts are necessary for

periodic maintenance and servicing, genuine

Ariens replacements must be used.

Ariens does not claim responsibility for

installation of unapproved parts and/or

accessories or damages as a result of their

use.

TRANSPORTING

Disengage power to the attachments when in

transport or not in use.

Do not tow this machine. Use a truck or trailer

to transport on public roads.

Do not use this machine on public roads.

P_,.',[_.'9=1_v_I:]Ib'dl

WARNING: AVOID INJURY!

Read and understand entire

Safety Section before

proceeding.

UNPACK UNIT

Remove all packing materials and hardware

and literature packages. Discard J hook used

with strapping as it is not needed for mower

operation.

GB- 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 105 106

Comments to this Manuals

No comments