Ariens 992807-ProZoom 60 Specifications download pdf (Page 20)

STARTING AND SHUT OFF

CAUTION: Read entire

,_ Owner/Operator Manual and

Engine Manual first. DO NOT

attempt to start the engine at this

time.

CAUTION: Always start and

,_ operate the engine in a well-

ventilated area. If in an enclosed

area, vent the exhaust outside.

To start the engine:

1. Sit properly in the seat, make sure the

steering controls are in the park position

and the PTO is off.

2. If the engine is cold, move the choke to

the On position. If the engine is warm,

do not use choke.

3. Move the throttle to the 3/4 fast position.

See Engine manual for detailed

instructions.

4. Put the key in the ignition switch and

turn it to the Start position. As soon as

the engine starts, release the key.

5. Move the choke control to the Off

position. Adjust the choke to keep the

engine running smoothly.

6. Allow the engine to warm for about five

minutes before operating the unit.

NOTE: Warming time will vary depending on

the ambient temperature. For temperatures

below 32 ° F (0° C), allow ten or more minutes

for the unit to warm.

7. Use the throttle to increase or decrease

engine speed. Set the throttle to the fast

position to cut grass.

To stop the engine:

1. Bring the steering levers to the neutral

position and disengage the PTO.

2. Move the throttle to the Slow position.

3. Turn the ignition key to the Off position.

Cold Weather Starting

NOTE: When starting in cold weather (below

-5 ° C (23° F)), do not run the starter more

than 10 seconds at a time. If the engine does

not start after 10 seconds allow the starter to

rest 30 seconds before trying again.

Stopping The Engine

Move the control levers to the park position,

idle the engine a few moments and turn the

ignition switch to the "Off" position. Remove

the key.

CAUTION: ALWAYS remove the

_l_ ignition key when the unit is not in

use.

STOPPING IN AN EMERGENCY

WARNING: Operating unit onslopes may lead to loss of

steering control. When operating

on slopes be prepared to react to

an emergency situation.

1. Return steering levers to neutral position

2. Immediately set parking brake

3. Turn off PTO and engine

ROLLOVER PROTECTIVE

STRUCTURE

,&

DANGER: AVOID INJURY[

Improperly installing or using

ROPS kits can lead to serious

injury or death. Read, understand

and follow all ROPS safety rules

in the owner/operator manual and

in the ROPS installation

instructions.

Do not weld, drill or alter the ROPS.

Damaged ROPS must not be straightened or

used. If damage does occur, contact your

Dealer and replace all damaged parts.

If the ROPS is lowered or removed from the

power unit for any reason, it must be raised

and/or reinstalled immediately. Original bolts

or equivalent replacements must be used and

tightened to the correct torque.

Do not attach chain, ropes, or cables to the

ROPS for pulling purposes as this will cause

the mower to tip backwards.

Ariens Company does not recommend the

use of the mower with the ROPS removed.

If you have a foldable ROPS, it can be folded

down for mower storage. It must be pinned in

the upright position prior to machine

operation.

SEAT BELT USAGE

With the ROPS installed, a seat belt must be

installed, used, and correctly adjusted at all

times. Replace damaged seat belts

immediately.

NEVER use a seat belt if operating with

ROPS folded down or removed.

GB - 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 105 106

Comments to this Manuals

No comments