Ariens 992807-ProZoom 60 Specifications download pdf (Page 28)

Figure16 OE3281

Oil Filter Change

Change the engine oil filter initially after the

first 8 hours of use. Change the engine oil

filter every 100 hours of operation after the

initial change.

1. Start the engine and run it for five

minutes to warm the engine oil.

2. Drain the engine oil into a suitable

container.

CAUTION: Before removing the

_, oil filter, place a suitable pan

under the filter connection.

3. Clean the area around the oil filter to

keep dirt and debris from the engine and

rotate the oil filter counterclockwise to

remove it. Wipe off the surface where

the filter mounts.

4. Coat a film of clean engine oil on the

seal of the new filter, see figure 17.

5. Install a new filter rotating it clockwise

until the seal contacts the mounting

surface. Rotate the filter an additional

3/4 of a turn by hand.

6. Reinstall drain plug and tighten.

7. Refill with engine oil as specified.

8. Run the engine for about 3 minutes, stop

engine, and check for leaks around filter.

Clean

Engine Oil

\\

Figure 17 ",,..

/

Engine Oil Change

WARNING: Engine oil is a toxic

,_ substance. Dispose of used oil

properly. Contact your local

authorities for approved disposal

methods or possible recycling.

Change the engine oil and filter after the first

8 hours of operation. Change the oil each

subsequent 100 hours of operation after the

initial change.

1. Run the engine to warm the oil.

2. Park the mower on level ground.

3. Stop the engine, put the steering control

levers in the park position and remove

the key.

4. Remove the oil drain screw, see

figure 18, and drain the oil into a suitable

container while the engine is still warm.

WARNING: Hot engine oil can

cause severe burns. Allow engine

oil temperature to drop from hot to

warm before attempting to drain

and handle the oil.

5. Install the oil drain screw.

6. Remove the dipstick and refill with fresh

oil.

7. Check the oil level.

GB - 28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 105 106

Comments to this Manuals

No comments