Ariens 911403-WAW 1034 Specifications download pdf (Page 12)

[e]'-]:I_,_:_Ii[e]_I

CONTROLS AND FEATURES

See Figure 6 for locations.

WARNING: Improper operation

A can lead to injury. Learn what the

controls do and how they work.

Thoroughly read and understand

entire Operator Manual.

CAUTION: AVOID INJURY. Read

A and understand the entire Safety

section before proceeding.

Parking Brake Lever (Right Hand

Lever)

Hold the parking brake lever against the

handlebar to release the wheel lock pin and

operate the unit.

Release the parking brake lever to engage

wheel lock pin and prevent the unit from

rolling forward or backward.

IMPORTANT: The wheel lock pin prevents

the unit from rolling forward or backward. The

unit can still pivot from side to side.

Parking Brake Engaged: Unit will

not roll forward or backward.

'_Brake Disengaged: Hold

lever against handlebar to operate

the unit.

PTO Clutch Lever (Left Hand Lever)

Hold down the lock lever and then squeeze

the pto clutch lever against the handlebar to

engage the clutch and start the mower

blades.

Release the clutch lever to stop the blades.

NOTE: The lock lever prevents the pto clutch

lever from being squeezed accidentally. It will

engage each time you release the clutch

lever.

PTO Disengaged: Mower blades

stop rotating.

PTO Engaged: Hold

lever and then hold clutch lever

against handlebar to engage the

clutch and start the mower blades.

CUTTING HEIGHT ADJUSTMENT

DANGER: Avoid injury from

A rotating blade.

ALWAYS shut off engine before

adjusting cutting height.

[.._4j ,_ [o,,]_"1_"1'_|

Spacers Cut Grass Length

Below Caster

Arms

0 1-3/4" (44.4 mm)

1 2" (50.8 mm)

2 2-1/2" (63.5 mm)

3 2-3/4" (69.8 mm)

4 3" (76.2 mm)

5 3-1/4" (82.6 mm)

6 3-1/2" (88.9 mm)

NOTE: Placing the spacers above the caster

arm lowers the deck and decreases cutting

height. Placing the spacers below the caster

arm raises the deck and increases the cutting

height.

To change cutting height, remove the lock pin

from the top of the caster fork. Support and

raise the deck slightly, turn the cutting height

spacers so the open end aligns with the flats

cut into the caster fork, and then remove the

spacers.

GB- 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 56 57

Comments to this Manuals

No comments