Ariens 911403-WAW 1034 Specifications download pdf (Page 17)

CHECK SPARK PLUG

Spark plug should be replaced every 100

hours of operation or each year.

NOTE: Loose spark plug wire terminals can

cause sparking. Replace terminal if

damaged.

CHECK ENGINE COOLING

,&

WARNING: HOT SURFACES can

cause death or serious injury. DO

NOT TOUCH parts which are hot

from operation. ALWAYS allow

parts to cool.

To prevent overheating, air must circulate

freely around the cooling fins, cylinder head

and block.

Every 100 hours of operation or yearly (more

often if conditions require) remove blower

housing and clean cooling fins. See engine

manual for instructions.

CHECK MUFFLER

Check muffler for debris, cracks, wear, or

other damage.

CAUTION: Replace worn-out

mufflers immediately. Continued

use could result in fire or

explosion.

[,,_o]=l V_4_I m]V_4m_'_l / _v_I =1_II_"]

CAUTION: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

PTO CLUTCH

WARNING: If you cannot adjust

the controls so the unit drives

properly, immediately take the unit

to your local authorized dealer for

repairs.

1. Test the pto clutch adjustment.

With the clutch disengaged, the blade

brake should touch the brake drum.

With the clutch engaged, the blade

brake should not touch the brake drum

and the deck belt should be under

tension.

2. Loosen the lock nut on the cable

adjuster under the dash panel.

3. Turn the adjuster body to tighten or

loosen the clutch cable.

NOTE: There must be some slack in the

clutch cable with the clutch disengaged.

4. Tighten the lock nut to hold the

adjustment.

IMPORTANT: If you cannot adjust the pto

clutch or if it fails to operate properly,

immediately take the unit to your Ariens

dealer for repair.

1. Cable 3. Check

Adjuster Slack

2. Lock Nut

Figure 10

GB - 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 56 57

Comments to this Manuals

No comments