Ariens 920013 Specifications download pdf (Page 21)

GB - 21

CHECK CLUTCH OPERATION

Auger / impeller must stop within 5 seconds

when attachment clutch/impeller brake lever

is released.

Wheels must stop quickly when traction drive

clutch lever is released.

If clutches do not engage or disengage

properly, adjust or repair before operation

(see Attachment Clutch/Brake Adjustment on

page 25 and Attachment Drive Belt

Replacement on page 27).

CLEAN ENGINE

Refer to Engine Manual for detailed

instructions.

CHECK ENGINE OIL

The engine crankcase oil should be checked

every 5 hours of operation. Oil level MUST be

maintained in safe operating range on

dipstick at all times or engine damage will

result (See Engine Manual).

Park unit on a level surface. Refer to Engine

Manual for detailed instructions.

CHANGE ENGINE OIL

Refer to Engine Manual for detailed

instructions.

CHECK TIRE PRESSURE

Keep tires at pressure listed on the tire

sidewall. (see Check Tire Pressure on

page 11).

CHECK AUGER GEARCASE

(Figure 16)

IMPORTANT: Proper oil level must be

maintained.

Gear cases are filled to the correct level at

the factory. Unless there is evidence of

leakage, no additional lubricant should be

required. Check oil level each season or

every 25 hours of operation.

IMPORTANT: Be sure unit is resting on a

level surface before checking lubricant levels.

To ensure adequate lubricant level:

1. Remove filler plug and seal washer

(Figure 16). Lubricant must be 1.63 in. –

1.88 in. (4.14 cm –4.78 cm) from the flat

surface of the inspecition cover.

IMPORTANT: DO NOT remove the

inspection cover.

2. Check oil level with suitable dipstick

device. Add lubricant if required.

IMPORTANT: Use only Ariens L3 synthetic

severe duty gear lube (Part Number

00068800). Use of other lubricants will void

unit warranty.

3. Reinstall filler screw and seal washer to

200 lbf-in. (22.6 N•m).

IMPORTANT: Improper torquing or omission

of seal washer will void unit warranty.

NOTE: Replace seal washer after every 5th

inspection.

Figure 16

1. Auger Gearcase

2. Filler Plug

3. Seal Washer

OS8195

2

1

3

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Comments to this Manuals

No comments