Ariens 920013 Specifications download pdf (Page 25)

GB - 25

SPEED SELECTOR

ADJUSTMENT

(Figure 24)

To adjust:

1. Disconnect adjustment pivot pin from

speed selector arm. Save hardware for

reinstallation.

2. Place the speed selector on dash panel

in the fastest forward speed position.

3. Turn the speed selector arm straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector arm, and

then turn it up the shift rod 7 turns. Insert

the pivot pin into hole.

5. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

6. Check forward and reverse speeds:

a. Start unit.

b. Shift speed selector into the first

forward speed.

c. Engage the traction clutch. Unit

should move forward.

d. Stop unit.

e. Shift speed selector into first

reverse speed.

f. Engage the traction clutch. Unit

should move backward.

g. Shut off unit.

7. Adjust pivot pin on the shift rod as

necessary so unit travels forward when

speed selector is in first forward position

and travels backward when speed

selector is in first reverse position.

8. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

ATTACHMENT CLUTCH/BRAKE

ADJUSTMENT

Remove Attachment Cable Slack

(Figure 25 and 26)

1. Loosen hardware securing belt cover to

unit.

NOTE: DO NOT completely remove the

hardware from unit.

2. Remove belt cover.

3. Loosen jam nut on cable adjustment

barrel, and then turn the adjustment

barrel down to shorten cable and

remove all cable slack (Figure 25).

WARNING: IMPROPER

ADJUSTMENT could result in

unexpected movement of auger and

impeller causing death or serious

injury. AUGER / IMPELLER MUST

STOP within 5 seconds when

Attachment Clutch/Impeller Brake

Lever is released.

WARNING: Adjustment procedure

requires the engine to be run with the

belt cover off. AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

Figure 24

1. Shift Rod

2. Adjustment Pivot Pin

3. Speed Selector Arm

4. Hairpin

2

4

1

3

OS8225

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Comments to this Manuals

No comments