Ariens 920013 Specifications download pdf (Page 28)

GB - 28

IMPORTANT: To avoid bending bottom cover,

when tipping unit apart, support handlebars

firmly or tip unit up on housing and remove

bottom cover by removing six cap screws

before separating unit.

8. Support Sno-Thro frame and housing.

9. Remove hex bolts securing housing to

frame (two on each side). Tip housing

and frame apart on pivot pin.

10. Separate housing from unit.

11. Remove attachment drive belt from

attachment pulley.

Replace Attachment Drive Belt

1. Place new belt onto attachment pulley

(Figure 32).

NOTE: Engage attachment clutch lever while

connecting housing to frame to hold brake out

of the way.

2. Tip housing and frame back together

and secure with hex bolts.

3. Place belt onto engine sheave.

4. Replace belt finger.

IMPORTANT: With the clutch lever engaged,

the belt finger located opposite the belt idler

must be less than 1/8 in. (3,2 mm) from the

belt, but not touching the belt, or belt

grabbing may occur causing impeller to rotate

while the attachment clutch is disengaged

(Figure 33).

5. Adjust clutch per Attachment

Clutch/Brake Adjustment on page 25.

6. Replace chute crank and secure with

hairpin.

920014 - Reconnect remote deflector

cable to dash control.

7. Run in the attachment belt. See Run-in

Attachment Belt on page 11.

8. Replace belt cover and tighten

hardware.

WARNING: AVOID INJURY. Auger

must stop within 5 seconds when

attachment lever is released or

serious injury or unit damage may

result.

Figure 31

1

2

3

4

1. Pinion Gear

2. Belt Cover

3. Hairpin

4. Chute Crank

OS8230

Figure 32

OS8235

5

3

2

1

6

7

8

4

1. Traction Belt

Idler

2. Traction Drive

Belt

3. Engine Sheave

4. Belt Finger

5. Attachment

Drive Belt

6. Attachment

Pulley

7. Attachment

Idler Nut

8. Attachment Belt

Idler

Figure 33

1. Belt Finger

2. Belt

1

2

1/8 in. (3,2 mm)

(Maximum)

OS8240

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comments to this Manuals

No comments