Ariens 915143-Zoom 50 Specifications

Browse online or download Specifications for Lawnmowers Ariens 915143-Zoom 50. Ariens 915143-Zoom 50 Specifications User Manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 1 - Zoom & ZT

Owner/Operator & Parts ManualModel815036Zoom & ZTBagger04088300A 2/10Printed in USA

Page 2 - INTRODUCTION

10INSTALL FRAME AND COVER ASSEMBLY(FIGURE 9)1. Position mounting plate weldment (item 13) on rear of unit frame and on both sides install 3/8-16 x 1.0

Page 3 - REQUIRED OPERATOR TRAINING

11INSTALL BAG ON FRAME (FIGURE 10)1. Thread the bag frames (item 8) through the sleeve on the open end of the mesh bag (item 10).2. Install the 3/8 x

Page 4 - SAFETY RULES

121. Flip up thumb latch and remove bagger hose from bagger cover assembly and bagger boot assembly (see figure 12 on page 12).2. Remove bagger boot a

Page 5

13BEFORE EACH USE1. Check bagger parts for wear, deterioration, or damage. Replace ONLY with Ariens/Gravely original service parts before operating.2.

Page 6

144. Empty the grass from each mesh bag.5. Install mesh bags back on bagger frame. Make sure that the heat-resistant side of the mesh bags face the un

Page 7 - ASSEMBLY

15IMPORTANT: NEVER spray unit with high-pressure water. DO NOT store unit outdoors.Clean plastic surfaces with sponge and mild detergent. Dry with a s

Page 8 - INSTALL COUNTERWEIGHT

16SAFETY DECALSItem Part No. Qty. Description1 05359700 1 Decal, Bagger Cover2 07897700 1 Decal, Boot CautionPARTS LISTOEe00212

Page 9 - INSTALL DECK BOOT

17BAGGER ASSEMBLY191520181423131716451467813151110142322241219153252627302928313233343536937123738

Page 10 - (FIGURE 9)

18BAGGER ASSEMBLY (CONTINUED)Item Part No. Qty. Description1 06802500 11 Rivet, Pop .187 x .4022 51513500 1 Cover, Bagger with Decal 3 06807600 28

Page 11 - INSTALL MESH BAGS (FIGURE 11)

19COUNTERWEIGHT ASSEMBLYItem Part No. Qty. Description1 06500010 2 Nut, Nyloc Flange .50-132 00172000 1 Weight, Cast Iron3 05965500 2 Bolt, Hex .50

Page 12

2Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Page 13 - OPERATION

ARIENS COMPANYGRAVELY® | STENS® | LOCKE® | NATIONAL® | BYNORM® | EVERRIDE® | GREAT DANE® Con_Ride_200820 Two-Year Limited Lawn and Garden Consumer R

Page 14 - MAINTENANCE

ARIENS COMPANYGRAVELY® | STENS® | LOCKE® | NATIONAL® | BYNORM® | EVERRIDE® | GREAT DANE® Con_Ride_200821 Exceptions and Limitations• Batteries are w

Page 15 - SPECIFICATIONS

Ariens CompanyGravely 655 West Ryan StreetBrillion, WI 54110-1072920-756-2141Fax 920-756-2407www.ariens.com or www.gravely.com

Page 16 - PARTS LIST

3NOTE: To locate your nearest Ariens Dealer, go to www.ariens.com on the internet. To locate your nearest Gravely Dealer, go to www.gravely.com on the

Page 17 - BAGGER ASSEMBLY

4SAFETY RULESDo not operate on slopes over 10°. DO NOT operate mower unless guards are in place or boot assembly and entire bagger are attached.NEVER

Page 18 - BAGGER ASSEMBLY (CONTINUED)

5Wear proper footwear to improve footing on slippery surfaces.Always wear safety goggles or safety glasses with side shields when operating mower.Movi

Page 19 - COUNTERWEIGHT ASSEMBLY

6NEVER allow children or others in or on towed equipment.On slopes, the weight of the towed equipment may cause loss of control.Travel slowly and allo

Page 20 - Consumer Ride-On Warranty

7TOOLS REQUIRED• Wrenches: 1/2”, 9/16”, 3/4” UNPACKING UNITIMPORTANT: Remove contents from carton carefully. Place cover assembly on a flat piece of c

Page 21

8INSTALL COUNTERWEIGHTIMPORTANT: Two people may be required to install the counterweight safely.NOTE: Install cast iron weight (item 2) on unit with t

Page 22

9INSTALL DECK BOOT1. Remove and retain discharge chute and discharge chute mount strap (figure 5). Retain all hardware.2. Remove and retain one nut fr

Comments to this Manuals

No comments