Ariens SNO-THRO 004-SS522E Specifications download pdf (Page 15)

GB - 15

DISCHARGE CHUTE DEFLECTOR

ADJUSTMENT

If discharge chute deflector does not stay in

position while throwing snow, adjust chute by

tightening fasteners (figure 10).

DRIVE BELT ADJUSTMENT

Adjust Auger Control Cable

(Figure 11)

1. Measure bail spring length with auger

clutch bail DISENGAGED.

2. Engage auger clutch bail.

3. Measure bail spring length with auger

clutch bail ENGAGED.

4. The difference in bail spring length

measurements should be 9/16 – 5/8 in.

(14.3 – 15.9 mm).

• If bail spring length IS within

specifications, go to Adjust Belt Finger.

• If bail spring length IS NOT within

specifications, go to Adjust Cable.

Adjust Cable

IMPORTANT: After adjustment, if the auger

control cable is taut when the auger clutch

bail is disengaged, the auger brake will not

work properly. If this condition occurs, replace

the belt and restart the drive belt adjustment

procedure.

1. Loosen jam nut on auger control cable

adjuster.

2. Turn adjustment barrel to lengthen or

shorten the cable as needed to achieve

spring extension defined in step 4 of

Adjust Auger Control Cable (Figure 11).

3. Tighten jam nut on auger control cable

adjuster.

Adjust Belt Finger (Figure 12)

1. Remove cowl.

IMPORTANT: Auger clutch bail MUST be

engaged while performing steps 2 through 5.

2. Engage auger clutch bail.

WARNING: Improper adjustment

could result in death or serious injury.

Auger brake MUST DISENGAGE

when clutch is engaged. Auger brake

MUST STOP AUGER WITHIN 5

SECONDS of releasing auger clutch

bail.

Fasteners

OS018

1

Figure 10

Measure Bail Spring Length With

Auger Clutch Bail Disengaged

Measure Bail Spring Length With

Auger Clutch Bail Engaged

Figure 11

OS3500

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments