Ariens SNO-THRO 004-SS522E Specifications download pdf (Page 13)

GB - 13

Tips for Operation

Snow is best removed as soon as possible

after a snow fall.

To clear an area, run unit in an overlapping

series of paths. For large areas, start in the

middle and throw snow to each side, so snow

is not cleared more than once.

ALWAYS direct snow away from area to be

cleared and with direction of the wind.

IMPORTANT: DO NOT overload unit capacity

by attempting to clear snow at too fast a rate.

TRAVELING TO ANOTHER WORK

AREA

1. Release auger clutch bail to disengage

auger.

2. Press down on handlebar enough to

raise front of unit slightly off the ground

and push or pull unit.

TRANSPORT

ALWAYS shut off engine and drain fuel when

transporting unit on a truck or trailer.

Use extra care when loading or unloading

unit onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure by rods or linkages that could

be damaged.

DO NOT transport machine while engine is

running.

Ariens Dealers will provide any service or

adjustments which may be required to keep

your unit operating at peak efficiency. Should

engine service be required, contact an Ariens

dealer or an authorized engine

manufacturer's service center

MAINTENANCE SCHEDULE

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

Interval Task Action

Each Use

Check Auger

Clutch

WARNING: Check auger clutch before each

use. Auger brake MUST DISENGAGE when

clutch is engaged. Auger brake MUST

STOP AUGER WITHIN 5 SECONDS of releasing

auger clutch bail (see Check Auger Clutch Bail on

page 10).

Clean Unit After each use, brush snow and debris off with a soft

bristled brush. Occasionally apply a light coat of

spray lubricant to exposed metal joints and surfaces.

Wipe off excess with soft cloth. Do not use abrasives

or harsh cleaners.

Follow Engine

Manual

Maintenance

Schedule

Perform scheduled engine maintenance. See

Engine Manual for detailed instructions.

Every 10 Hours

Check Fasteners Make sure all hardware is tightened properly.

Check Drive Belt

Adjustment

See Drive Belt Adjustment on page 15.

Yearly

Check Scraper

Blade

Check scraper blade for wear. DO NOT allow

scraper blade to wear down too far or auger housing

will become damaged.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Comments to this Manuals

No comments

Ariens SNO-THRO 004-SS522E Specifications Page 13

Comments to this Manuals

Related products and manuals for Snow throwers Ariens SNO-THRO 004-SS522E