Ariens Pro-24 Brush Cutter Specifications download pdf (Page 7)

GB - 7

This product is equipped with an internal

combustion engine. DO NOT use on or near

any unimproved, forest or brush covered land

unless the exhaust system is equipped with a

spark arrestor meeting applicable local, state

or federal laws. A spark arrestor, if used,

must be maintained in effective working order

by the operator. See your Ariens Dealer or

engine manufacturer’s service center.

Accidental engine start up can cause death or

serious injury. Except where specifically

recommended, ALWAYS stop engine wait for

moving parts to stop, allow parts to cool and

disconnect spark plug wire before inspecting,

servicing, adjusting or repairing unit.

Avoid Electric Shock. DO NOT disconnect

wire from spark plug while engine is running.

Keep equipment in good condition.

Maintain or replace safety and instruction

labels, as necessary.

Follow engine manufacturer’s safety

instruction when servicing engine.

Check all hardware at regular intervals,

especially blade attachment bolts. Keep all

hardware properly tightened.

An extension spring, when extended, stores

energy and can be dangerous. Always use

tools specifically designed for installing or

removing an extension spring. Always

compress or extend springs slowly.

Before tipping unit, remove fuel and battery (if

equipped).

Use extra care when loading or unloading

unit onto trailer or truck.

CAUTION: DO NOT drop machine when

loading or unloading or damage to rear axle

may occur.

Ensure all wheel blocks, jack stands and tie

downs will support unit during maintenance.

Replace worn-out mufflers immediately.

Continued use could result in fire or

explosion.

Sharp edges can cut or amputate fingers or a

hand. Wrap blade or wear sturdy gloves to

service.

Only replace blades. NEVER straighten or

weld blades.

Use only replacement parts designed for your

unit. See your Ariens Dealer.

Allow engine to cool before storing in any

enclosure.

ALWAYS clean unit before extended storage.

See engine manual for proper storage.

DO NOT store unit inside a building with fuel

in the fuel tank where any ignition sources

are present.

Use only accessories which have been

approved by Ariens and are properly

installed.

Use only accessories or attachments that are

designed for your unit and that can be used

safely on your terrain.

Check attachments frequently and replace

worn or damaged components with

manufacturer’s recommended parts.

Fuel and Fuel System

Fuel is highly flammable and its vapors are

explosive. Handle with care. Use only an

approved gasoline container with an

appropriately sized dispensing spout.

•NO Smoking!

•NO Sparks!

•NO Flames!

• Allow engine to cool before filling fuel

tank.

Gasoline with up to 10% ethanol (gasohol) or

up to 10% MTBE (methyl tertiary butyl ether)

is acceptable. Use of any gasoline other than

those approved above will void the engine

warranty.

IMPORTANT: Refer to Engine Manual for

proper fuel type.

DO NOT OVERFILL. Fill fuel tank to below

bottom of filler neck to allow for fuel

expansion.

NOTE: See SPECIFICATIONS on page 29.

Never fill containers inside a vehicle or on a

truck or trailer bed with a plastic liner. Always

place containers on the ground away from

your vehicle before filling.

When practical, remove gas-powered

equipment from the truck or trailer and refuel

it on the ground. If this is not possible, then

refuel such equipment on a trailer with a

portable container, rather than from a

gasoline dispenser nozzle.

Keep the nozzle in contact with the rim of the

fuel tank or container opening at all times until

fueling is complete. Do not use a nozzle lock-

open device.

Check fuel supply before starting engine.

DO NOT fill gasoline tank indoors, when

engine is running, or while engine is hot.

Allow engine to cool several minutes before

removing fuel cap.

Replace gasoline tank cap securely and

clean any spilled fuel before starting engine.

If fuel is spilled on clothing, change clothing

immediately.

NEVER store fuel inside where there is an

open flame, such as a water heater.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Ariens Pro-24 Brush Cutter Specifications Page 7

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens Pro-24 Brush Cutter