Ariens Pro-24 Brush Cutter Specifications download pdf (Page 8)

GB - 8

ALWAYS drain fuel outdoors away from

ignition sources.

ALWAYS shut off engine, and remove key,

and close fuel shutoff valve when transporting

unit on a truck or trailer.

Emission Control System

This equipment and/or its engine may include

exhaust and evaporative emissions control

system components required to meet U.S.

Environmental Protection Agency (EPA)

and/or California Air Resources Board

(CARB) regulations. Tampering with

emission controls and components by

unauthorized personnel may result in severe

fines or penalties. Emission controls and

components can only be adjusted by an

Ariens Company dealer or an authorized

engine manufacturer's service center.

Contact your Ariens Company Equipment

Retailer concerning emission controls and

component questions.

ASSEMBLY

NOTE: The mounting hardware described in

the following assembly procedures is factory-

mounted on the mower in the proper

locations.

Handlebar Installation

1. Remove mower and handlebar from

carton.

2. Slowly pull out recoil starter rope to

create enough slack to allow handlebar

to be rotated up and back.

NOTE: Lower ends of handlebar are

mounted forward of fuel tank and muffler.

3. Rotate handlebar up and back, while

simultaneously pulling both handlebar

supports back to vertical position, until

handlebar lower ends are near frame

mounting points. See Figure 3.

NOTE: Do not remove cable tie securing

control cable to each handlebar support.

4. Remove cable tie securing actuation link

to handlebar on each side. See Figures

3 and 4.

ASSEMBLY

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

Figure 3

1. Frame

2. Handlebar

3. Handlebar

Support

4. Cable

1

3

4

2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments