Ariens 986101 Specifications download pdf (Page 10)

GB - 10

Cutting Angle Adjuster

(Figure 7)

Controls the cutting angle of the blade for

decorative edging.

1. Push the lever forward to unlock the

head and then rotate it left or right to set

the desired edging angle.

NOTE: The head pivots from about

70 degrees to 180 degrees.

IMPORTANT: Make sure the front wheel

does not contact the blade when angling the

blade for a beveled edge.

Rear Wheel Height Adjuster

(Figure 7)

Sets the rear wheel height to support the

edger when working along curbs or other

uneven terrain.

1. Loosen the knob and position the wheel

so it supports the unit level when

operating, and then securely tighten the

knob.

NOTE: Set the wheel height before starting

the engine or engaging the blades.

Front Wheel Adjuster

(Figure 8)

Positions the front wheel on the axle to

balance the unit when working along curbs or

other uneven terrain.

NOTE: Make sure the front wheel rolls on the

work surface.

IMPORTANT: Make sure the cutting blade

will not contact wheel before starting the

engine.

1. With the engine shut off, remove the pin

from the axle and position the front

wheel on the right or left side of the axle

as needed, and secure in position with

the hair pin.

Position the wheel away from the blade

when bevel cutting or trimming.

Position the wheel nearer the blade for

edging.

Rotate the head to the desired angle.

Make sure the lever locks into place.

Push the lever forward slightly

to unlock the head.

Figure 6

The head pivots from about

70 degrees to 180 degrees.

Loosen knob,

position wheel

at the desired

height and

replace the

knob.

Figure 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Comments to this Manuals

No comments