Ariens 915157-Zoom 34 Specifications download pdf (Page 27)

EN - 27

U1 Battery Installation

(Figures 19 and 20)

1. Remove factory battery. See “Remove

Factory-Installed Battery” on page 26.

NOTE: Be sure to cut cable tie connecting

positive battery cable to battery hold down

bracket.

2. Set battery inside the frame, underneath

the seat with terminals positioned as

shown (Figure 20).

3. Place battery hold down bracket on top

of the battery. Attach the curved end of

the bracket in the upper mounting hole

in the wall of the frame (Figure 19).

4. Position bolt through the mounting hole

nearest to the battery and through

mounting bracket. Secure with nut.

IMPORTANT: Tighten nut until battery is

secure and will not move or rattle in the

frame.

5. Connect positive (+) cable first, then

negative (–) cable.

6. Apply petroleum jelly or dielectric grease

to battery cable ends and terminals.

7. Tip seat back. See “TIPPING SEAT

FORWARD” on page 22.

Cleaning Battery and Battery Cables

(Figure 18)

1. Tip seat forward. See “TIPPING SEAT

FORWARD” on page 22.

2. Disconnect negative (–) cable first, then

positive (+) cable.

3. Clean battery cable ends, negative (–)

terminal, and positive (+) terminal with a

wire brush and rinse with a weak baking

soda solution.

4. Connect positive (+) cable first, then

negative (–) cable.

5. Apply petroleum jelly or dielectric grease

to battery cable ends and terminals.

6. Tip seat back. See “TIPPING SEAT

FORWARD” on page 22.

Charging the Battery

(Figure 18)

Follow First Aid directions for contact with

battery fluid.

• External Contact: Flush with water.

• Eyes: Flush with water for at least 15

minutes and get medical attention

immediately!

• Internal Contact: Drink large quantities

of water. Follow with Milk of Magnesia,

beaten egg or vegetable oil. Get

medical attention immediately!

• In case of internal contact, DO NOT

induce vomiting!

IMPORTANT: DO NOT fast charge. Charging

at a higher rate will damage or destroy

battery.

IMPORTANT: ALWAYS follow information

provided on battery and battery charger.

Contact battery and battery charger

manufacturers’ for detailed instructions.

1. Remove battery from unit. See “Factory-

Installed Battery Removal and

Installation” on page 26.

2. Place battery in a well-ventilated area.

3. Connect positive (+) lead of charger to

positive (+) terminal, and negative (–)

lead of charger to negative (–) terminal.

Figure 20

1. Positive (+) Terminal

2. Positive (+) Cable

3. Battery Hold-Down Bracket

4. Battery

5. Negative (–) Terminal

6. Negative (–) Cable

7. Nut

8. Bolt

3

5

1

2

4

6

7

8

WARNING: FROZEN

BATTERIES CAN EXPLODE and

result in death or serious injury.

DO NOT charge a frozen battery.

Let the battery thaw before

charging.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Comments to this Manuals

No comments