Ariens HVZ 915085-2350 Service Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 53
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
5 - 17
5.2 CHECKING ENGINE OIL
Check the engine oil prior to use.
IMPORTANT: Never operate the engine with the oil
below the low mark on the dipstick.
See the engine manual for oil specifications and oil
filter service instructions.
5.3 CHANGING OIL
Engine muffler and other parts will be hot if unit has
been running.
1. Engine oil should be changed after the first five
hours of operation and every 25 hours there after.
2. Move the unit to a level and well ventilated area
and set the parking brake.
3. If the engine is cold, let the unit run for five
minutes.
4. When the engine is warm, stop the engine.
5. Clean the area around the dipstick and (drain
hose).
6. Put an open container that will hold one gallon of
oil under the drain hose.
7. Open the drain valve or drain plug (see Figure 14).
8. Allow the engine oil to drain completely into the
one gallon container. Remove container and
contents for future recycling as required.
9. Close the oil drain valve.
10.If used; remove the oil filter.
11.Clean the oil filter port and install a new oil filter
according to the instructions on the oil filter. Fill
with new oil to the "full" mark on the dipstick.
12.Start and run the engine for one minute. Stop the
engine and recheck the oil level and add as
necessary.
13.Check for leakage at the drain plug and oil filter if
used. Tighten the fittings as necessary if leakage
occurs.
14.Release the parking brake.
15.Return the unit into service.
Figure 14
5.4 CHECKING ENGINE COOLING
IMPORTANT: To prevent severe damage to the
engine, proper cooling must be maintained.
1. The air intake screen must be kept clean. Remove
any grass, dirt, or debris that may have
accumulated.
2. Check the engine cooling yearly.
5.5 CLEANING THE AIR CLEANER
See the manufacturer’s manual for cleaning
instructions.
The operator should check the air cleaner element
daily and clean if necessary.
1. Clean the air cleaner precleaner every 25 hours.
See your engine manual for instructions.
2. Apply oil and reinstall over the paper air filter
element.
3. Wipe out the air cleaner cover to remove any dirt
build up in the cover.
4. Reinstall the cover over the air cleaner before
operating the engine.
5.6 CHANGING THE AIR CLEANER
ELEMENT
Replace the air cleaner element when clogged or every
100 hours. Do not attempt to clean. See
manufacturer’s manual for instructions.
5.7 INSPECTING THE MUFFLER/SPARK
ARRESTER
Inspect muffler and (if equipped) spark arrester.
Replace muffler if corroded, leaking, or loose. A
defective muffler can create a fire hazard and/or
damage engine.
5.8 REPLACE SPARK PLUGS
Spark plug type and gap setting are listed in
Specifications. See manufacturer’s manual for detailed
instructions.
WARNING: DO NOT touch parts which are
hot. Allow parts to cool before servicing.
Past Production
Drain valve. Press in
and rotate CCW to
drain or CW to close
Current Production
Drain plug
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

Comments to this Manuals

No comments