Ariens HVZ 915085-2350 Service Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 53
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
6 - 20
6.1 REPLACING MOWER BLADE
Remove (Figure 16)
1. Block mower blades (5) to prevent rotation.
2. Remove mounting hardware and mower blades
from mower deck.
Install
1. Install mower blades (5) to spindles (1) on mower
deck with mounting hardware.
2. Torque 3/8-inch hex bolt (4) to 80 to 120 lbf-ft (108
to 163 N·m).
Figure 16
6.2 SHARPENING MOWER BLADE
CAUTION: DO NOT sharpen mower blade while on
unit. An unbalanced mower blade will cause excessive
vibration and eventual damage to unit. Check mower
blade balance prior to reinstalling mower blades.
NEVER weld or straighten mower blades.
1. Remove mower blade from unit (see Replacing
Mower Blade).
Ariens recommends having mower blades sharpened
by a professional. Contact your Ariens dealer.
Discard mower blade if (Figure 17):
More than 1/2 in. (1.27 cm) of metal is removed.
The air lift erosion area is eroded.
The mower blade is bent or broken.
Do not change angle of cutting edge or round the
corner at the end of mower blade.
2. Sharpen mower blade by removing an equal
amount of material from each end of mower blade.
3. Check mower blade balance by sliding mower
blade on round rod. If blade is balanced, it should
remain in a horizontal position. If either end of
mower blade moves downward, sharpen the heavy
end until mower blade is balanced.
4. Install mower blade on unit (see Replacing Mower
Blade).
Figure 17
SECTION 6 - MOWER DECK
CAUTION: Mower blades are sharp and can
cut you. Wrap the blades or wear gloves, and
use extra caution when servicing them.
OE0039
1. Spindle Assembly
2. Flat Washer
3. Bevel Washer
4. 3/8-inch Hex Bolt
5. Mower Blade
1
3
4
5
2
DO NOT Sharpen to this Pattern
Sharpen to this Pattern
Discard if more
than 1/2 in.
(1.27 cm)
1. Air Lift Erosion Area
2. Cutting Edge
OE0052
1 2
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 52 53

Comments to this Manuals

No comments