Ariens HVZ 915085-2350 Service Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 53
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
4 - 8
4.2 MOVING UNIT MANUALLY
WARNING: DO NOT disengage or bypass
transmission and coast downhill
Disengage (1) transmission bypass levers to drive unit
and engage (2) transmission bypass levers to push unit
manually (Figure 3).
Figure 3
4.3 FILLING THE FUEL TANK
NO smoking, NO sparks, NO flames.
Refer to manufacturer’s engine manual for proper fuel.
Be sure to follow all safety precautions in Safety
section when adding fuel to the fuel tank.
4.4 GENERAL LUBRICATION
Each front caster has a grease fitting.
All grease fittings should be greased at 25-hour
intervals. Clean and inspect parts and replace as
required.
1. Clean the fittings before attaching the grease gun.
2. Use Stens Mix Hi-Temp grease (a moly-lithium
grease) or equivalent. Add grease until it appears
at the ends of the bearing or ends of the shaft.
3. Check all parts for wear and damage.
4. Every 25 hours apply motor oil to all pin
connections, pivots points and areas where sliding
occurs.
4.5 MOWER DECK REMOVAL AND
INSTALLATION
Figure 4
Remove (Figure 4)
1. Remove PTO belt from electric clutch (see
Replacing the PTO Belt).
2. Remove front and rear trunnions from lift arms om
each side of the deck.
3. Slide mower deck out from under unit.
Install
1. Slide mower deck under unit.
2. Install front and rear trunnions on lift arms on each
side of the deck.
3. Install PTO belt on electric clutch (see Replacing
the PTO Belt).
4. Level and adjust pitch of mower deck (see Leveling
And Adjusting Pitch Of Mower Deck).
WARNING: Fuel is highly flammable and its
vapors are explosive. Handle with care.
oe0011
1. Transmission Bypass Lever Disengaged
2. Transmission Bypass lever Engaged
2
1
CAUTION: Before performing any service or
adjustments:
Turn PTO switch "OFF".
Park mower on a hard, flat, level surface.
Place steering control levers in neutral
lock (fully outward) position.
Set parking brake.
Turn ignition switch "OFF" and remove
key.
Wait for blades and all moving parts to
stop.
DSCN7683
1. Rear Trunnion
2. PTO Belt
3. Mower Deck
4. Front Trunnion
5. Lift Arm (typical)
1 2 43 5
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 52 53

Comments to this Manuals

No comments